I could not make eql driver to work.
following is my command. I hope someone would help me.
I use redHat 6.0.
/sbin/modprobe eql
/sbin/ifconfig eql 192.168.0.1 mtu 1524
/etc/sysconfig/network-scripts/ifup-ppp ifcfg-ppp0
eql_enslave eql ppp0 56000
/sbin/route add default eql
after I type this command,I can't access the Internet.
/sbin/ifconfig
eql Link encap:Serial Line IP
inet addr:192.168.0.1 Mask:255.255.255.0
UP RUNNING MASTER MTU:1524 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:126 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:5
eth0 Link encap:Ethernet HWaddr 00:90:27:10:39:3E
inet addr:192.168.0.10 Bcast:192.168.0.255 Mask:255.255.255.0
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:17405 errors:0 dropped:0 overruns:0 frame:0
TX packets:15613 errors:0 dropped:0 overruns:0 carrier:0
collisions:127 txqueuelen:100
Interrupt:10 Base address:0xe400
lo Link encap:Local Loopback
inet addr:127.0.0.1 Mask:255.0.0.0
UP LOOPBACK RUNNING MTU:3924 Metric:1
RX packets:19 errors:0 dropped:0 overruns:0 frame:0
TX packets:19 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
ppp0 Link encap:Point-to-Point Protocol
inet addr:202.101.175.252 P-t-P:202.96.108.53 Mask:255.255.255.255
UP POINTOPOINT RUNNING NOARP SLAVE MULTICAST MTU:1524 Metric:1
RX packets:13639 errors:0 dropped:0 overruns:0 frame:0
TX packets:14460 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:10
/sbin/route
Destination Gateway Genmask Flags Metric Ref Use Iface
192.168.0.10 * 255.255.255.255 UH 0 0 0 eth0
202.96.108.53 * 255.255.255.255 UH 0 0 0 ppp0
192.168.0.0 * 255.255.255.0 U 0 0 0 eth0
192.168.0.0 * 255.255.255.0 U 0 0 0 eql
127.0.0.0 * 255.0.0.0 U 0 0 0 lo
default * 0.0.0.0 U 0 0 0 eql
default 202.96.108.53 0.0.0.0 UG 0 0 0 ppp0
Regards
oscar
[EMAIL PROTECTED]
-----------------------------------------------
��ӭʹ����ѵ����ʼ�ϵͳ http://www.188.net/
��ӭʹ����ѵ��Ӻؿ�ϵͳ http://card.188.net/
ʱ������http://time.188.net/
-
To unsubscribe from this list: send the line "unsubscribe linux-net" in
the body of a message to [EMAIL PROTECTED]
