Hi
I guess that the Cisco router acts as a router and not a bridge...
If it's a bridge then you don't have to do anything...
But as I said, I guess it routes packets...
What you need to do is add another address range on the DHCP server bound
to the ethernet interface. The address range should be from the same
subnet that the Token Ring interface is on.
Now, on the Cisco enable the helper service for udp broadcasts, so DHCP
requests on the TokenRing would be forwarded to the DHCP server
I think, but I'm not 100% sure, that it is done like that:
conf t
interface T 0
ip helper-address <ip address of DHCP server>
there might be more to be done...
If it's not working contact me....
Hope it works...
-------------------
Arie Vayner
Netvision - Networking Department
http://www.netvision.net.il
email: [EMAIL PROTECTED]
tel: 972-4-8560402 fax: 972-4-8550345
mobile: 972-51-767457
On Thu, 25 May 2000 [EMAIL PROTECTED] wrote:
> Date: Thu, 25 May 2000 10:42:36 +1200
> From: [EMAIL PROTECTED]
> To: [EMAIL PROTECTED]
> Subject: DHCP server on Linux6.1-- Help??
>
>
>
> Hello, everyone
> I have installed a DHCP server on my Redhat Linux 6.1 server. It works fine for
> my Ethernet network. But I have another Token ring network in my LAN. They are
> using different IP subnet.
>
> My DHCP server only have a Ethernet card. The IP is 173.64.10.16. The Ethernet
> subnet is 173.64.0.0. The Token Ring subnet is 173.10.0.0. There is a CISCO
> router between the Ethernet and Token Ring.
>
> My question is how to get the Token Ring connect on my DHCP server. What do I
> need change in the dhcpd.conf file?
>
>
>
> -
> To unsubscribe from this list: send the line "unsubscribe linux-net" in
> the body of a message to [EMAIL PROTECTED]
>
-
To unsubscribe from this list: send the line "unsubscribe linux-net" in
the body of a message to [EMAIL PROTECTED]
