?? this isn't what you want alright :)
If your lan is connected to eth1:
First of all: a router can only route between two different subnets and
the IP ranges you gave to the router (64.240.90.230 and 64.240.90.231)
are in the same subnet. That can only if you make it proxy-arp
Secondly: you told your router that 64.240.90.224/28 is connected to
eth0 and eth1, there can be only one, neo! remove the entry for eth1.
Thirdly: you have 2 default-routes, one to eth0 and one to eth1. Both
are pointing at 64.240.90.225, which resides in the lan-subnet.
I think you need to study ip-address assigning and subnetting a bit. If
even then you can't figure it out, add more info, what is the isp's
gateway address, what addresses do you want where..
Serge.
-----Original Message-----
From: Vinay Kudithipudi [mailto:[EMAIL PROTECTED]]
Sent: donderdag 3 augustus 2000 17:01
To: [EMAIL PROTECTED]
Subject: Network Routing Configuration
Hello Guys,
Thanks for the great feed back on firewalls. I have a question
about routing tables. I have two network cards in the comp that I am
planning to use as an firewall. Both of them have pulic ip addresses.
One card is going to be connected to the router and another to the
lan. How should I write the routing table so that all the traffic is
passed on from the card attached to the lan. My routing table at
present is
Kernel IP routing table
Destination Gateway Genmask Flags Metric Ref Use
Iface
64.240.90.231 * 255.255.255.255 UH 0 0 0
eth1
64.240.90.230 * 255.255.255.255 UH 0 0 0
eth0
64.240.90.224 * 255.255.255.240 U 0 0 0
eth0
64.240.90.224 * 255.255.255.240 U 0 0 0
eth1
127.0.0.0 * 255.0.0.0 U 0 0 0
lo
default 64.240.90.225 0.0.0.0 UG 0 0 0
eth1
default 64.240.90.225 0.0.0.0 UG 0 0 0
eth0
--
Best regards,
Vinay mailto: [EMAIL PROTECTED]
-
To unsubscribe from this list: send the line "unsubscribe linux-net" in
the body of a message to [EMAIL PROTECTED]
-
To unsubscribe from this list: send the line "unsubscribe linux-net" in
the body of a message to [EMAIL PROTECTED]
