Hi Gurus and fellow newbies, I've installed and initialized a Digi international's X4 920 serial board that can handle 4 peripherals (like printers and modems). My plan is to allow access to my Linux box via modem. At this time if I dial from work, the two machines connect for a brief moment (about 5 secs). Digi support says that I need to use the "cu" command to setup the modem so that it will receive incoming calls. They wont say anymore than that. I've searched the web but to no avail... I'm not sure what to look for. So, I'm turning my fellow Linux Penguins... I need your thoughts, ideas and suggestions as to what to do or where to go to find info on how to get this thing working. Thanks Chris Job "when excellence is available, good is not enough"
