After installing RH61 on a cpq 221 smartarray card (raid 1 over two 9.1
gig drives) I noticed that the block size was 4096. Is there a way to
change this?
I suspect that I could partition out the drive and format a
ext2fs with 1024 and then install without formatting the dev, but I would
like to know I can change this setting.
=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=
David Hajoglou "Hojo" --UNC Delta U. 1998--
Director of Voice and Data Communications/Linux Sys. Admin.
iSoft Corp. Phone: 1.303.539.0513 x202 Fax: .0512
=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=
c:\winnt> secure_nt.exe
Securing NT. Insert Linux boot disk to continue......
-
To unsubscribe from this list: send the line "unsubscribe linux-newbie" in
the body of a message to [EMAIL PROTECTED]
Please read the FAQ at http://www.linux-learn.org/faqs