In Linux, NAT is called ipchains. Visit
http://www.linuxheadquarters.com/howto/networking/ipchains.shtml for
instructions on how to set it up for your network. It is much easier to follow
than the LDP HOWTO.
Tammy
On Thu, 03 Aug 2000, Ray Olszewski wrote:
> At 07:36 PM 8/3/00 -0500, Eric Peeters wrote:
> >Hello all,
> >
> >I am exploring the possibility of building a Linux-based firewall for a
> >small network and I am wondering whether I can implement NAT (Network
> >Address Translation) on a Red Hat Linux 6.2 and if yes, how I go about doing
> >that.
>
> Yes, you can; people do it all the time. I think the RH stock kernel even
> has the stuff you need compiled in (other distributions don't and you need
> to compile you orn kernel).
>
> Look at the Firewall HowTo (at www.linuxdoc.org) for general guidence on the
> process, and don't hesitate to report with specific questions it leaves
> unresolved.
>
> >The box in question would be connected at one NIC to the router and at the
> >other NIC to the LAN's switch.
> >
> >
> This is a standard router/NAT/firewall setup for Linux. Remember to check if
> the connection between the Linux router and the other router requires a
> crossover cable (you don't say what the other device is, and both "device"
> and "hub" wired kinds exist).
>
>
> --
> ------------------------------------"Never tell me the odds!"---
> Ray Olszewski -- Han Solo
> Palo Alto, CA [EMAIL PROTECTED]
> ----------------------------------------------------------------
>
-
To unsubscribe from this list: send the line "unsubscribe linux-newbie" in
the body of a message to [EMAIL PROTECTED]
Please read the FAQ at http://www.linux-learn.org/faqs
