Change omap_cf.c and omap_nor.c to use omap_readw/writew instead of __REG.
This is needed for multi-omap in the future.
Cc: David Brownell <[EMAIL PROTECTED]>
Cc: [EMAIL PROTECTED]
Cc: [EMAIL PROTECTED]
Signed-off-by: Tony Lindren <[EMAIL PROTECTED]>
diff --git a/arch/arm/mach-omap1/board-osk.c b/arch/arm/mach-omap1/board-osk.c
index a66505f..82ec34c 100644
--- a/arch/arm/mach-omap1/board-osk.c
+++ b/arch/arm/mach-omap1/board-osk.c
@@ -267,13 +267,17 @@ static struct i2c_board_info __initdata
osk_i2c_board_info[] = {
static void __init osk_init_smc91x(void)
{
+ u32 l;
+
if ((gpio_request(0, "smc_irq")) < 0) {
printk("Error requesting gpio 0 for smc91x irq\n");
return;
}
/* Check EMIFS wait states to fix errors with SMC_GET_PKT_HDR */
- EMIFS_CCS(1) |= 0x3;
+ l = omap_readl(EMIFS_CCS(1));
+ l |= 0x3;
+ omap_writel(l, EMIFS_CCS(1));
}
static void __init osk_init_cf(void)
@@ -526,13 +530,16 @@ static void __init osk_mistral_init(void) { }
static void __init osk_init(void)
{
+ u32 l;
+
/* Workaround for wrong CS3 (NOR flash) timing
* There are some U-Boot versions out there which configure
* wrong CS3 memory timings. This mainly leads to CRC
* or similar errors if you use NOR flash (e.g. with JFFS2)
*/
- if (EMIFS_CCS(3) != EMIFS_CS3_VAL)
- EMIFS_CCS(3) = EMIFS_CS3_VAL;
+ l = omap_readl(EMIFS_CCS(3));
+ if (l != EMIFS_CS3_VAL)
+ omap_writel(EMIFS_CS3_VAL, EMIFS_CCS(3));
osk_flash_resource.end = osk_flash_resource.start = omap_cs3_phys();
osk_flash_resource.end += SZ_32M - 1;
diff --git a/drivers/mtd/maps/omap_nor.c b/drivers/mtd/maps/omap_nor.c
index 240b0e2..fb7ba78 100644
--- a/drivers/mtd/maps/omap_nor.c
+++ b/drivers/mtd/maps/omap_nor.c
@@ -60,13 +60,22 @@ struct omapflash_info {
static void omap_set_vpp(struct map_info *map, int enable)
{
static int count;
-
- if (enable) {
- if (count++ == 0)
- OMAP_EMIFS_CONFIG_REG |= OMAP_EMIFS_CONFIG_WP;
- } else {
- if (count && (--count == 0))
- OMAP_EMIFS_CONFIG_REG &= ~OMAP_EMIFS_CONFIG_WP;
+ u32 l;
+
+ if (cpu_class_is_omap1()) {
+ if (enable) {
+ if (count++ == 0) {
+ l = omap_readl(EMIFS_CONFIG);
+ l |= OMAP_EMIFS_CONFIG_WP;
+ omap_writel(l, EMIFS_CONFIG);
+ }
+ } else {
+ if (count && (--count == 0)) {
+ l = omap_readl(EMIFS_CONFIG);
+ l &= ~OMAP_EMIFS_CONFIG_WP;
+ omap_writel(l, EMIFS_CONFIG);
+ }
+ }
}
}
diff --git a/drivers/pcmcia/omap_cf.c b/drivers/pcmcia/omap_cf.c
index 46314b4..569b746 100644
--- a/drivers/pcmcia/omap_cf.c
+++ b/drivers/pcmcia/omap_cf.c
@@ -38,19 +38,19 @@
#define CF_BASE 0xfffe2800
/* status; read after IRQ */
-#define CF_STATUS_REG __REG16(CF_BASE + 0x00)
+#define CF_STATUS (CF_BASE + 0x00)
# define CF_STATUS_BAD_READ (1 << 2)
# define CF_STATUS_BAD_WRITE (1 << 1)
# define CF_STATUS_CARD_DETECT (1 << 0)
/* which chipselect (CS0..CS3) is used for CF (active low) */
-#define CF_CFG_REG __REG16(CF_BASE + 0x02)
+#define CF_CFG (CF_BASE + 0x02)
/* card reset */
-#define CF_CONTROL_REG __REG16(CF_BASE + 0x04)
+#define CF_CONTROL (CF_BASE + 0x04)
# define CF_CONTROL_RESET (1 << 0)
-#define omap_cf_present() (!(CF_STATUS_REG & CF_STATUS_CARD_DETECT))
+#define omap_cf_present() (!(omap_readw(CF_STATUS) & CF_STATUS_CARD_DETECT))
/*--------------------------------------------------------------------------*/
@@ -139,11 +139,11 @@ omap_cf_set_socket(struct pcmcia_socket *sock, struct
socket_state_t *s)
return -EINVAL;
}
- control = CF_CONTROL_REG;
+ control = omap_readw(CF_CONTROL);
if (s->flags & SS_RESET)
- CF_CONTROL_REG = CF_CONTROL_RESET;
+ omap_writew(CF_CONTROL_RESET, CF_CONTROL);
else
- CF_CONTROL_REG = 0;
+ omap_writew(0, CF_CONTROL);
pr_debug("%s: Vcc %d, io_irq %d, flags %04x csc %04x\n",
driver_name, s->Vcc, s->io_irq, s->flags, s->csc_mask);
@@ -270,7 +270,7 @@ static int __init omap_cf_probe(struct platform_device
*pdev)
omap_cfg_reg(V10_1610_CF_IREQ);
omap_cfg_reg(W10_1610_CF_RESET);
- CF_CFG_REG = ~(1 << seg);
+ omap_writew(~(1 << seg), CF_CFG);
pr_info("%s: cs%d on irq %d\n", driver_name, seg, irq);
@@ -279,14 +279,15 @@ static int __init omap_cf_probe(struct platform_device
*pdev)
* CF/PCMCIA variants...
*/
pr_debug("%s: cs%d, previous ccs %08x acs %08x\n", driver_name,
- seg, EMIFS_CCS(seg), EMIFS_ACS(seg));
- EMIFS_CCS(seg) = 0x0004a1b3; /* synch mode 4 etc */
- EMIFS_ACS(seg) = 0x00000000; /* OE hold/setup */
+ seg, omap_readl(EMIFS_CCS(seg)), omap_readl(EMIFS_ACS(seg)));
+ omap_writel(0x0004a1b3, EMIFS_CCS(seg)); /* synch mode 4 etc */
+ omap_writel(0x00000000, EMIFS_ACS(seg)); /* OE hold/setup */
/* CF uses armxor_ck, which is "always" available */
pr_debug("%s: sts %04x cfg %04x control %04x %s\n", driver_name,
- CF_STATUS_REG, CF_CFG_REG, CF_CONTROL_REG,
+ omap_readw(CF_STATUS), omap_readw(CF_CFG),
+ omap_readw(CF_CONTROL),
omap_cf_present() ? "present" : "(not present)");
cf->socket.owner = THIS_MODULE;
diff --git a/include/asm-arm/arch-omap/tc.h b/include/asm-arm/arch-omap/tc.h
index 8ded218..65a9c82 100644
--- a/include/asm-arm/arch-omap/tc.h
+++ b/include/asm-arm/arch-omap/tc.h
@@ -75,16 +75,14 @@
#ifndef __ASSEMBLER__
/* EMIF Slow Interface Configuration Register */
-#define OMAP_EMIFS_CONFIG_REG __REG32(EMIFS_CONFIG)
-
#define OMAP_EMIFS_CONFIG_FR (1 << 4)
#define OMAP_EMIFS_CONFIG_PDE (1 << 3)
#define OMAP_EMIFS_CONFIG_PWD_EN (1 << 2)
#define OMAP_EMIFS_CONFIG_BM (1 << 1)
#define OMAP_EMIFS_CONFIG_WP (1 << 0)
-#define EMIFS_CCS(n) __REG32(EMIFS_CS0_CONFIG + (4 * (n)))
-#define EMIFS_ACS(n) __REG32(EMIFS_ACS0 + (4 * (n)))
+#define EMIFS_CCS(n) (EMIFS_CS0_CONFIG + (4 * (n)))
+#define EMIFS_ACS(n) (EMIFS_ACS0 + (4 * (n)))
/* Almost all documentation for chip and board memory maps assumes
* BM is clear. Most devel boards have a switch to control booting
@@ -93,13 +91,13 @@
*/
static inline u32 omap_cs0_phys(void)
{
- return (OMAP_EMIFS_CONFIG_REG & OMAP_EMIFS_CONFIG_BM)
+ return (omap_readl(EMIFS_CONFIG) & OMAP_EMIFS_CONFIG_BM)
? OMAP_CS3_PHYS : 0;
}
static inline u32 omap_cs3_phys(void)
{
- return (OMAP_EMIFS_CONFIG_REG & OMAP_EMIFS_CONFIG_BM)
+ return (omap_readl(EMIFS_CONFIG) & OMAP_EMIFS_CONFIG_BM)
? 0 : OMAP_CS3_PHYS;
}
--
To unsubscribe from this list: send the line "unsubscribe linux-omap" in
the body of a message to [EMAIL PROTECTED]
More majordomo info at http://vger.kernel.org/majordomo-info.html
