Re: MUSB not workin in .27rc6, was: Re: OMAP support in mainline?

[Koen Kooi]

Op 19 sep 2008, om 23:24 heeft Felipe Balbi het volgende geschreven:

On Fri, Sep 19, 2008 at 06:09:04PM +0200, Koen Kooi wrote:

Op 18 sep 2008, om 11:55 heeft Felipe Balbi het volgende geschreven:

On Wed, Sep 17, 2008 at 03:23:49PM +0200, ext Koen Kooi wrote:

Op 17 sep 2008, om 14:24 heeft Steve Sakoman het volgende geschreven:

On Wed, Sep 17, 2008 at 12:16 AM, Koen Kooi
<[EMAIL PROTECTED]>
wrote:

And they aren't working too well with current l-o git either with
MUSB
being
broken. There's a patch to fix client mode, but host mode still
isn't
working.

Host mode musb is working just fine on Overo with the "set

(and can't check since I don't have my Beagle board with me at the
moment)

transceiver" patch. Not sure why you are having trouble with Beagle

I should clarify: OTG mode with a host cable doesn't work in .27rc,
it does
work in 2.6.26. I haven't tried specifying pure hostmode, only OTG.
I would try it on the evm as well, but that is having serious irq
issues
with .27rc, pressing a key on the keypad triggers an irq overrun,
ethernet
gives an oops on boot when trying to register and irq etc,etc.
2.6.27 is
looking really, really bad on omap3 at the moment.

Yeah, we lost some musb history when it went to mainline. I didn't
test
this patch yet cuz I've been quite busy at work, but it should make
beagle work. Could you tell me if makes it work ?


index 9d2dcb1..f7fe91e 100644
--- a/drivers/usb/musb/omap2430.c
+++ b/drivers/usb/musb/omap2430.c
@@ -215,12 +215,14 @@ void musb_platform_set_mode(struct musb *musb,
u8 musb_mode)

int __init musb_platform_init(struct musb *musb)
{
+       struct otg_transceiver *xceiv = otg_get_transceiver();
      u32 l;

#if defined(CONFIG_ARCH_OMAP2430)
      omap_cfg_reg(AE5_2430_USB0HS_STP);
#endif

+       memcpy(musb->xceiv, xceiv, sizeof(*xceiv));
      musb_platform_resume(musb);

      l = omap_readl(OTG_SYSCONFIG);

diff --git a/drivers/usb/musb/omap2430.c b/drivers/usb/musb/ omap2430.c

mode is broken (tested on beagle and evm by me).

Ok, another datapoint: client mode (tested on beagle by Måns) and host mode (tested on overo by Steve) work with a similar patch as above, OTG

I don't recall having otg (id pin handling) working on omap3. I have
some experimental patches on my local branch (they work, but need
clean up).

regards,

Koen

If I boot up the .26 l-o kernel with mini-a attached, it works as expected.

--
balbi

PGP.sig
Description: This is a digitally signed message part