Hi Geert, On Thursday 24 April 2014 12:13:19 Geert Uytterhoeven wrote: > On SoCs like ARM/SH-mobile, gate clocks are available for modules, allowing > Runtime PM for a device controlled by a gate clock. > > On legacy shmobile kernels, this is handled by the PM runtime code in > drivers/sh/pm_runtime.c, which installs a clock notifier for the platform > bus, registering the "NULL" clock of each platform device with the PM core. > This approach is also used on davinci, keystone, and omap1.
This requires the device to have the MSTP clock defined as the first clock in its DT node. I'm not against that, but the requirement should be clearly documented, and we need to check existing DT bindings to make sure they comply with that. I'd like to also take this as an opportunity to discuss how we should name clocks in DT bindings for Renesas devices. Most devices have a single MSTP clock, in which case we don't specify a name. Other devices need several clocks. Names for the non-MSTP clocks will obviously be device-dependent, but how should the MSTP clock be called in that time ? Should it have an empty name (a "" string in DT) ? Should it have a standard name ? Maybe "fck" for "functional clock" ? > On multi-platform shmobile kernels, this was not handled at all, leading > to spurious disabled clocks on drivers relying on Runtime PM, depending on > implicit reset state, or on the bootloader. > > A first solution, enabling the PM runtime code in drivers/sh/pm_runtime.c > in a multi-platform-safe way, was provided by the patch series > "[PATCH v2 00/17] ARM: shmobile: Enable drivers/sh/pm_runtime.c on > multi-platform" (http://www.spinics.net/lists/linux-sh/msg30887.html). > > Here is an alternative approach, avoiding the reliance on C board files, > which are being phased out. > > This is also related to a patch series by Felipe Balbi ("[RFC/PATCH] base: > platform: add generic clock handling for platform-bus", > https://lkml.org/lkml/2014/1/31/290) > > This series: > 1. Lets the MSTP clock driver indicate that its clocks are suitable for > Runtime PM, > 2. Lets the DT code retrieve clock information when adding a device > (it already retrieves information for resources (registers, irq) --- > unfortunately clocks are not resources), and registering clocks > suitable for Runtime PM with the PM core. > If Runtime PM is disabled, the clocks are just enabled. > > Note that this works for devices instantiated from DT only. > Fortunately the drivers for the remaining platform devices (SCI and CMT) > handle clocks theirselves, without Runtime PM, so they get properly enabled. > > Patches: > - [1/4] clk: Add CLK_RUNTIME_PM and clk_may_runtime_pm() > - [2/4] PM / clock_ops: Add pm_clk_add_clk() > - [3/4] of/clk: Register clocks suitable for Runtime PM with the > - [4/4] clk: shmobile: mstp: Set CLK_RUNTIME_PM flag > > This series was tested on Renesas r8a7791, using the Koelsch development > board. -- Regards, Laurent Pinchart -- To unsubscribe from this list: send the line "unsubscribe linux-omap" in the body of a message to majord...@vger.kernel.org More majordomo info at http://vger.kernel.org/majordomo-info.html