Add sw_babble_control() logic to differentiate between transient babble and real babble condition. Also add the SW babble control register definitions.
Babble control register logic is implemented in the latest revision of AM335x. Signed-off-by: George Cherian <george.cher...@ti.com> --- drivers/usb/musb/musb_dsps.c | 50 ++++++++++++++++++++++++++++++++++++++++++++ drivers/usb/musb/musb_regs.h | 7 +++++++ 2 files changed, 57 insertions(+) diff --git a/drivers/usb/musb/musb_dsps.c b/drivers/usb/musb/musb_dsps.c index f6f3087..868caf8 100644 --- a/drivers/usb/musb/musb_dsps.c +++ b/drivers/usb/musb/musb_dsps.c @@ -536,6 +536,56 @@ static int dsps_musb_set_mode(struct musb *musb, u8 mode) return 0; } +static int sw_babble_control(struct musb *musb) +{ + int timeout = 10; + u8 babble_ctl, session_restart = 0; + + babble_ctl = dsps_readb(musb->mregs, MUSB_BABBLE_CTL); + dev_dbg(musb->controller, "babble: MUSB_BABBLE_CTL value %x\n", + babble_ctl); + /* + * check line monitor flag to check whether babble is + * due to noise + */ + dev_dbg(musb->controller, "STUCK_J is %s\n", + babble_ctl & MUSB_BABBLE_STUCK_J ? "set" : "reset"); + + if (babble_ctl & MUSB_BABBLE_STUCK_J) { + /* + * babble is due to noise, then set transmit idle (d7 bit) + * to resume normal operation + */ + babble_ctl = dsps_readb(musb->mregs, MUSB_BABBLE_CTL); + babble_ctl |= MUSB_BABBLE_FORCE_TXIDLE; + dsps_writeb(musb->mregs, MUSB_BABBLE_CTL, babble_ctl); + + /* wait till line monitor flag cleared */ + dev_dbg(musb->controller, "Set TXIDLE, wait J to clear\n"); + do { + babble_ctl = dsps_readb(musb->mregs, MUSB_BABBLE_CTL); + udelay(1); + } while ((babble_ctl & MUSB_BABBLE_STUCK_J) && timeout--); + + /* check whether stuck_at_j bit cleared */ + if (babble_ctl & MUSB_BABBLE_STUCK_J) { + /* + * real babble condition is occured + * restart the controller to start the + * session again + */ + dev_dbg(musb->controller, "J not cleared, misc (%x)\n", + babble_ctl); + session_restart = 1; + } + + } else { + session_restart = 1; + } + + return session_restart; +} + static int dsps_musb_reset(struct musb *musb) { struct device *dev = musb->controller; diff --git a/drivers/usb/musb/musb_regs.h b/drivers/usb/musb/musb_regs.h index 03f2655..b9bcda5 100644 --- a/drivers/usb/musb/musb_regs.h +++ b/drivers/usb/musb/musb_regs.h @@ -72,6 +72,12 @@ #define MUSB_DEVCTL_HR 0x02 #define MUSB_DEVCTL_SESSION 0x01 +/* BABBLE_CTL */ +#define MUSB_BABBLE_FORCE_TXIDLE 0x80 +#define MUSB_BABBLE_SW_SESSION_CTRL 0x40 +#define MUSB_BABBLE_STUCK_J 0x20 +#define MUSB_BABBLE_RCV_DISABLE 0x04 + /* MUSB ULPI VBUSCONTROL */ #define MUSB_ULPI_USE_EXTVBUS 0x01 #define MUSB_ULPI_USE_EXTVBUSIND 0x02 @@ -246,6 +252,7 @@ */ #define MUSB_DEVCTL 0x60 /* 8 bit */ +#define MUSB_BABBLE_CTL 0x61 /* 8 bit */ /* These are always controlled through the INDEX register */ #define MUSB_TXFIFOSZ 0x62 /* 8-bit (see masks) */ -- 1.8.3.1 -- To unsubscribe from this list: send the line "unsubscribe linux-omap" in the body of a message to majord...@vger.kernel.org More majordomo info at http://vger.kernel.org/majordomo-info.html