On 09/15/2014 07:01 PM, Sebastian Andrzej Siewior wrote: > On 09/11/2014 04:35 PM, Peter Hurley wrote: >> I do need to find out if omap hardware sets UART_MSR_DCTS when auto CTS >> is on. Would you mind running the debug patch below with HW flow control on? > > I didn't forget about this. However I told minicom to use hardware flow > control (and I see the driver set the HW bit) but I haven't seen that > uart_handle_cts_change() has been invoked at all. I'm going to check > two other boards and report then.
No, I don't get into this at all function. So I connected my am335x-evm with beagle board xm because both of them have an old fashion UART connector (instead those uart-to-usb). Both configured with HW-Flow and I haven't seen the function invoked but I saw "port->icount.overrun" being incremented. This shouldn't happen. So I am a little puzzled here… >> Regards, >> Peter Hurley > Sebastian -- To unsubscribe from this list: send the line "unsubscribe linux-omap" in the body of a message to majord...@vger.kernel.org More majordomo info at http://vger.kernel.org/majordomo-info.html
