On 26/08/2014 at 16:17:57 +0200, Tomasz Figa wrote :
> Firmware on certain boards (e.g. ODROID-U3) can leave incorrect L2C prefetch
> settings configured in registers leading to crashes if L2C is enabled
> without overriding them. This patch introduces bindings to enable
> prefetch settings to be specified from DT and necessary support in the
> driver.
>
> Signed-off-by: Tomasz Figa <t.f...@samsung.com>
Tested-by: Alexandre Belloni <alexandre.bell...@free-electrons.com>
It is working and useful on Atmel's sama5d4 were the bootloader is not
configuring the L2C prefetch. However, I'm wondering whether we should
add support for setting L310_PREFETCH_CTRL_DATA_PREFETCH and
L310_PREFETCH_CTRL_INSTR_PREFETCH. I'm currently doing it by using
".l2c_aux_val = L310_AUX_CTRL_DATA_PREFETCH |
L310_AUX_CTRL_INSTR_PREFETCH" (those are the same bits) but this has the
disadvantage of displaying the "L2C: platform modifies aux control
register:" twice.
> + if (!of_property_read_u32(np, "arm,prefetch-offset", &val)) {
> + prefetch &= ~L310_PREFETCH_CTRL_OFFSET_MASK;
> + prefetch |= val & L310_PREFETCH_CTRL_OFFSET_MASK;
> + }
> +
While you use val directly here, later, while printing the offset, val +
1 is used. Maybe it would be better to have the same number in both
places, else you end up with having "arm,prefetch-offset = <1>" in your
DT and the kernel printing "L2C-310 ID prefetch enabled, offset 2
lines".
--
Alexandre Belloni, Free Electrons
Embedded Linux, Kernel and Android engineering
http://free-electrons.com
--
To unsubscribe from this list: send the line "unsubscribe linux-omap" in
the body of a message to majord...@vger.kernel.org
More majordomo info at http://vger.kernel.org/majordomo-info.html
