Quoting Jyri Sarha (2014-09-11 01:44:24) > On 09/10/2014 01:14 AM, Mike Turquette wrote: > > Quoting Jyri Sarha (2014-09-05 05:21:34) > >> The added gpio-gate-clock is a basic clock that can be enabled and > >> disabled trough a gpio output. The DT binding document for the clock > >> is also added. For EPROBE_DEFER handling the registering of the clock > >> has to be delayed until of_clk_get() call time. > >> > >> Signed-off-by: Jyri Sarha <jsa...@ti.com> > >> --- > >> > >> This is my final attempt to get this generic gpio controlled basic > >> clock into mainline. Of course I gladly fix any issues that the patch > >> may have. However, if there is no response, I give up and move it to TI > >> specific clocks. > >> > > > > I searched through my archives and found a post from January. You Cc'd > > me as "<mturque...@linaro.org>". Note that the address is wrapped in > > chevrons but there is no name string (e.g. "Mike Turquette"). > > > > My mailer doesn't parse this well it was not flagged as to:me in my > > filters. Maybe other mailers handle this better? If you leave out the > > name string in the future then it would probably be best to drop the > > chevrons. > > > > Then git send-email adds the chevrons, but in the future I'll put the > name string there too. > > >> I've been sending this patch as a part of Beaglebone-Black HDMI audio > >> patch series since last autumn. Since the previous version I have done > >> some minor cleanups and changed the clock's compatible property from > >> "gpio-clock" to "gpio-gate-clock". All the file names, comments, > >> etc. have also been changed accordingly. > > > > Is your platform the only one to take advantage of this clock type so > > far? I feel that it is esoteric enough that it shouldn't be made > > generic. > > > > The main reason is that all of the generic clock types needs to be > > overhauled at some point. E.g. the clk-gate should have its > > machine-specific logic separated from its machine-independent logic. If > > the gate clock were to populate .enable and .disable callbacks and then > > leave the actual register banging, or regmap'ing, or gpio'ing up to your > > backend driver then that would be a big improvement and would avoid the > > need to create this new clock type outright. > > > > So that's on my todo list, but it's not done yet. For your patch I think > > that putting this code into drivers/clk/ti would probably be best, > > unless other folks could use it as-is. Even if others could use it today > > I would want to remove it eventually for the reasons stated in the > > paragraph above. > > > > Ok, I see. I do not know of anybody else needing a gpio gate clock at > the moment. I'll put the driver under drivers/clk/ti unless someone > comes forward soon.
Well nobody came forward but after thinking about it I've seen this design elsewhere, so it should probably be generic. And the underlying machine-specific ops are less relevant to this type since most of that is abstracted away behind the GPIO api. Applied to clk-next. Let me know if that causes a problem for you if you have merged this into the TI clk stuff. Regards, Mike > > Thanks, > Jyri > -- To unsubscribe from this list: send the line "unsubscribe linux-omap" in the body of a message to majord...@vger.kernel.org More majordomo info at http://vger.kernel.org/majordomo-info.html