On Sat, Nov 29, 2014 at 4:35 PM, Felipe Balbi <ba...@ti.com> wrote: > Hi, > > On Fri, Nov 28, 2014 at 11:35:53AM +0100, Yegor Yefremov wrote: >> On Wed, Nov 19, 2014 at 6:53 PM, Tony Lindgren <t...@atomide.com> wrote: >> > * Enric Balletbo Serra <eballe...@gmail.com> [141119 03:14]: >> >> 2014-11-18 16:42 GMT+01:00 Tony Lindgren <t...@atomide.com>: >> >> >> >> Checked again, and no luck. It's very weird because from the OTG point >> >> of view, OTG is exactly the same between Beagleboard-XM and IGEPv2. >> >> >> >> Can you confirm that you're using kernel 3.18-rc5 without other >> >> patches applied ? At this moment, I don't have a Beagleboard-XM to >> >> test, I'll try to get one because at this moment I'm a bit stuck with >> >> this problem. >> > >> > Yes it was with v3.18-rc5 and the defconfig patch I posted except >> > I had to disable all the other MUSB platforms. Also tested it with >> > built in modules. >> > >> > Maybe you need to check the .dts pinctrl entries for hsusb0_* lines? >> >> Just my 2 cents, My am335x based board shows similar symptoms >> (CONFIG_USB_MUSB_DUAL_ROLE enabled). Only if I specify dr_mode = >> "host"; in my DTS I get device enumerated. 3.15, that I had before >> made no problems as OTG. > > Are you sure your ID pin is properly routed ? If you set dr_mode to otg, > then you *must* have a properly routed ID pin and use a proper > micro-/mini-ab receptacle. That's not true for e.g. beagle bone black. > > One USB port is using a Standard-A while the other uses mini-B. You > can't do any role swapping with those.
Yes, I'm sure, that ID pin is routed properly. It is also not BBB, but real device Baltos iR 5221 (http://visionsystems.de/produkte/baltos-ir-5221.html). With 3.15 I'm able to use OTG port both as device and host. I boot the device, insert FTDI based hardware into OTG port and my ttyUSBx devices, then disconnect and connect to PC and I get usb0 network interface and can communicate with PC. Yegor -- To unsubscribe from this list: send the line "unsubscribe linux-omap" in the body of a message to majord...@vger.kernel.org More majordomo info at http://vger.kernel.org/majordomo-info.html