We are moving to device tree support on OMAP3, but that currently
breaks ADP1653 driver. This adds device tree support, plus required
documentation.

Signed-off-by: Pavel Machek <pa...@ucw.cz>

---

Changed -microsec to -us, as requested by devicetree people.

Fixed checkpatch issues.

diff --git a/Documentation/devicetree/bindings/leds/common.txt 
b/Documentation/devicetree/bindings/leds/common.txt
index 2d88816..2c6c7c5 100644
--- a/Documentation/devicetree/bindings/leds/common.txt
+++ b/Documentation/devicetree/bindings/leds/common.txt
@@ -14,6 +14,15 @@ Optional properties for child nodes:
      "ide-disk" - LED indicates disk activity
      "timer" - LED flashes at a fixed, configurable rate
 
+- max-microamp : maximum intensity in microamperes of the LED
+                (torch LED for flash devices)
+- flash-max-microamp : maximum intensity in microamperes of the
+                       flash LED; it is mandatory if the LED should
+                      support the flash mode
+- flash-timeout-microsec : timeout in microseconds after which the flash
+                           LED is turned off
+
+
 Examples:
 
 system-status {
@@ -21,3 +30,10 @@ system-status {
        linux,default-trigger = "heartbeat";
        ...
 };
+
+camera-flash {
+       label = "Flash";
+       max-microamp = <50000>;
+       flash-max-microamp = <320000>;
+       flash-timeout-microsec = <500000>;
+}
diff --git a/Documentation/devicetree/bindings/media/i2c/adp1653.txt 
b/Documentation/devicetree/bindings/media/i2c/adp1653.txt
new file mode 100644
index 0000000..3c7065f
--- /dev/null
+++ b/Documentation/devicetree/bindings/media/i2c/adp1653.txt
@@ -0,0 +1,38 @@
+* Analog Devices ADP1653 flash LED driver
+
+Required Properties:
+
+  - compatible: Must contain one of the following
+    - "adi,adp1653"
+
+  - reg: I2C slave address
+
+  - gpios: References to the GPIO that controls the power for the chip.
+
+There are two led outputs available - flash and indicator. One led is
+represented by one child node, nodes need to be named "flash" and "indicator".
+
+Required properties of the LED child node:
+- max-microamp : see Documentation/devicetree/bindings/leds/common.txt
+
+Required properties of the flash LED child node:
+
+- flash-max-microamp : see Documentation/devicetree/bindings/leds/common.txt
+- flash-timeout-us : see Documentation/devicetree/bindings/leds/common.txt
+
+Example:
+
+        adp1653: led-controller@30 {
+                compatible = "adi,adp1653";
+               reg = <0x30>;
+                gpios = <&gpio3 24 GPIO_ACTIVE_HIGH>; /* 88 */
+
+               flash {
+                        flash-timeout-us = <500000>;
+                        flash-max-microamp = <320000>;
+                        max-microamp = <50000>;
+               };
+                indicator {
+                        max-microamp = <17500>;
+               };
+        };
diff --git a/arch/arm/boot/dts/omap3-n900.dts b/arch/arm/boot/dts/omap3-n900.dts
index bc82a12..d04e7cc 100644
--- a/arch/arm/boot/dts/omap3-n900.dts
+++ b/arch/arm/boot/dts/omap3-n900.dts
@@ -553,6 +558,22 @@
 
                ti,usb-charger-detection = <&isp1704>;
        };
+
+       adp1653: led-controller@30 {
+               compatible = "adi,adp1653";
+               reg = <0x30>;
+               gpios = <&gpio3 24 GPIO_ACTIVE_HIGH>; /* 88 */
+
+               flash {
+                       flash-timeout-us = <500000>;
+                       flash-max-microamp = <320000>;
+                       max-microamp = <50000>;
+               };
+
+               indicator {
+                       max-microamp = <17500>;
+               };
+       };
 };
 
 &i2c3 {
diff --git a/drivers/media/i2c/adp1653.c b/drivers/media/i2c/adp1653.c
index 873fe19..78341d0 100644
--- a/drivers/media/i2c/adp1653.c
+++ b/drivers/media/i2c/adp1653.c
@@ -8,6 +8,7 @@
  * Contributors:
  *     Sakari Ailus <sakari.ai...@iki.fi>
  *     Tuukka Toivonen <tuukka...@gmail.com>
+ *      Pavel Machek <pa...@ucw.cz>
  *
  * This program is free software; you can redistribute it and/or
  * modify it under the terms of the GNU General Public License
@@ -34,9 +35,12 @@
 #include <linux/module.h>
 #include <linux/i2c.h>
 #include <linux/slab.h>
+#include <linux/of_gpio.h>
 #include <media/adp1653.h>
 #include <media/v4l2-device.h>
 
+#include <linux/gpio.h>
+
 #define TIMEOUT_MAX            820000
 #define TIMEOUT_STEP           54600
 #define TIMEOUT_MIN            (TIMEOUT_MAX - ADP1653_REG_CONFIG_TMR_SET_MAX \
@@ -306,9 +318,18 @@ adp1653_init_device(struct adp1653_flash *flash)
 static int
 __adp1653_set_power(struct adp1653_flash *flash, int on)
 {
-       int ret;
+       int ret = 0;
+
+       if (flash->platform_data->power)
+               ret = flash->platform_data->power(&flash->subdev, on);
+       else {
+               gpio_set_value(flash->platform_data->power_gpio, on);
+               if (on) {
+                       /* Some delay is apparently required. */
+                       udelay(20);
+               }
+       }
 
-       ret = flash->platform_data->power(&flash->subdev, on);
        if (ret < 0)
                return ret;
 
@@ -316,8 +337,13 @@ __adp1653_set_power(struct adp1653_flash *flash, int on)
                return 0;
 
        ret = adp1653_init_device(flash);
-       if (ret < 0)
+       if (ret >= 0)
+               return ret;
+
+       if (flash->platform_data->power)
                flash->platform_data->power(&flash->subdev, 0);
+       else
+               gpio_set_value(flash->platform_data->power_gpio, 0);
 
        return ret;
 }
@@ -407,21 +433,78 @@ static int adp1653_resume(struct device *dev)
 
 #endif /* CONFIG_PM */
 
+static int adp1653_of_init(struct i2c_client *client,
+                          struct adp1653_flash *flash,
+                          struct device_node *node)
+{
+       u32 val;
+       struct adp1653_platform_data *pd;
+       enum of_gpio_flags flags;
+       int gpio;
+       struct device_node *child;
+
+       if (!node)
+               return -EINVAL;
+
+       pd = devm_kzalloc(&client->dev, sizeof(*pd), GFP_KERNEL);
+       if (!pd)
+               return -ENOMEM;
+       flash->platform_data = pd;
+
+       child = of_get_child_by_name(node, "flash");
+       if (!child)
+               return -EINVAL;
+       if (of_property_read_u32(child, "flash-timeout-microsec", &val))
+               return -EINVAL;
+
+       pd->max_flash_timeout = val;
+       if (of_property_read_u32(child, "flash-max-microamp", &val))
+               return -EINVAL;
+       pd->max_flash_intensity = val/1000;
+
+       if (of_property_read_u32(child, "max-microamp", &val))
+               return -EINVAL;
+       pd->max_torch_intensity = val/1000;
+
+       child = of_get_child_by_name(node, "indicator");
+       if (!child)
+               return -EINVAL;
+       if (of_property_read_u32(child, "max-microamp", &val))
+               return -EINVAL;
+       pd->max_indicator_intensity = val;
+
+       if (!of_find_property(node, "gpios", NULL)) {
+               dev_err(&client->dev, "No gpio node\n");
+               return -EINVAL;
+       }
+
+       gpio = of_get_gpio_flags(node, 0, &flags);
+       if (gpio < 0) {
+               dev_err(&client->dev, "Error getting GPIO\n");
+               return -EINVAL;
+       }
+
+       pd->power_gpio = gpio;
+       return 0;
+}
+
+
 static int adp1653_probe(struct i2c_client *client,
                         const struct i2c_device_id *devid)
 {
        struct adp1653_flash *flash;
        int ret;
 
-       /* we couldn't work without platform data */
-       if (client->dev.platform_data == NULL)
-               return -ENODEV;
-
        flash = devm_kzalloc(&client->dev, sizeof(*flash), GFP_KERNEL);
        if (flash == NULL)
                return -ENOMEM;
 
        flash->platform_data = client->dev.platform_data;
+       if (!flash->platform_data) {
+               ret = adp1653_of_init(client, flash, client->dev.of_node);
+               if (ret)
+                       return ret;
+       }
 
        mutex_init(&flash->power_lock);
 
@@ -438,10 +521,11 @@ static int adp1653_probe(struct i2c_client *client,
                goto free_and_quit;
 
        flash->subdev.entity.type = MEDIA_ENT_T_V4L2_SUBDEV_FLASH;
-
+
        return 0;
 
 free_and_quit:
+       dev_err(&client->dev, "adp1653: failed to register device\n");
        v4l2_ctrl_handler_free(&flash->ctrls);
        return ret;
 }
@@ -464,7 +551,7 @@ static const struct i2c_device_id adp1653_id_table[] = {
 };
 MODULE_DEVICE_TABLE(i2c, adp1653_id_table);
 
-static struct dev_pm_ops adp1653_pm_ops = {
+static const struct dev_pm_ops adp1653_pm_ops = {
        .suspend        = adp1653_suspend,
        .resume         = adp1653_resume,
 };


-- 
(english) http://www.livejournal.com/~pavelmachek
(cesky, pictures) 
http://atrey.karlin.mff.cuni.cz/~pavel/picture/horses/blog.html
--
To unsubscribe from this list: send the line "unsubscribe linux-omap" in
the body of a message to majord...@vger.kernel.org
More majordomo info at  http://vger.kernel.org/majordomo-info.html

Reply via email to