* ch...@ti.com <ch...@ti.com> [091109 06:25]:
> From: Charulatha V <ch...@ti.com>
> 
> This patch disables a GPIO module when all pins of a GPIO
> module are inactive (clock gating forced at module level) and
> enables the module when any gpio in the module is requested.
> 
> The module is enabled only when mod_usage indicates that no GPIO
> in that  module is currently active and the GPIO being requested
> is the 1st one to be active in that module.
> 
> Each module would be disabled in omap_gpio_free() API when all
> GPIOs in a particular module becomes inactive. The module is
> re-enabled in omap_gpio_request() API when a GPIO is requested
> from the module that was previously disabled.
> 
> Since individual GPIO's bookkeeping is introduced automatically
> in this patch(mod_usage), the same is used in omap_set_gpio_debounce()
> & omap_set_gpio_debounce_time() APIs to ensure that the gpio being
> used is actually "requested" prior to being used (Nishant Menon's
> <n...@ti.com> Suggestion)
> 
> Higher layer keeps track of GPIOs individually. This patch
> introduces bookkeeping information, modulewise in lower layer
> since disabling clock is done at module level. GPIO module level
> details are specific to hardware and introducing APIs in higher
> level layer to handle them might not be correct. Hence GPIO module
> level information (mod_usage) has to be handled only in
> low-level layer.
> 
> Signed-off-by: Charulatha V <ch...@ti.com>
> Acked-by: Nishanth Menon <n...@ti.com>
> ---
>  arch/arm/plat-omap/gpio.c |   35 +++++++++++++++++++++++++++++++++++
>  1 files changed, 35 insertions(+), 0 deletions(-)
> 
> diff --git a/arch/arm/plat-omap/gpio.c b/arch/arm/plat-omap/gpio.c
> index 4c35f9f..5ee6a60 100644
> --- a/arch/arm/plat-omap/gpio.c
> +++ b/arch/arm/plat-omap/gpio.c
> @@ -199,6 +199,7 @@ struct gpio_bank {
>       struct gpio_chip chip;
>       struct clk *dbck;
>       u32 dbck_enable_mask;
> +     u32 mod_usage;
>  };
>  
>  #define METHOD_MPUIO         0
> @@ -691,6 +692,12 @@ void omap_set_gpio_debounce(int gpio, int enable)
>       reg += OMAP24XX_GPIO_DEBOUNCE_EN;
>  #endif
>  
> +     if ((cpu_is_omap24xx() || cpu_is_omap34xx() || cpu_is_omap44xx())
> +                     && (!(bank->mod_usage & l))) {
> +             printk(KERN_ERR "GPIO not requested\n");
> +             return;
> +     }
> +
>       spin_lock_irqsave(&bank->lock, flags);
>       val = __raw_readl(reg);
>  
> @@ -726,6 +733,12 @@ void omap_set_gpio_debounce_time(int gpio, int enc_time)
>       bank = get_gpio_bank(gpio);
>       reg = bank->base;
>  
> +     if ((cpu_is_omap24xx() || cpu_is_omap34xx() || cpu_is_omap44xx())
> +                     && (!bank->mod_usage)) {
> +             printk(KERN_ERR "GPIO not requested\n");
> +             return;
> +     }
> +
>       enc_time &= 0xff;
>  #ifdef CONFIG_ARCH_OMAP4
>       reg += OMAP4_GPIO_DEBOUNCINGTIME;

Please just use:

        if (!cpu_class_is_omap1()) {
                ...
        }

> @@ -1219,6 +1232,16 @@ static int omap_gpio_request(struct gpio_chip *chip, 
> unsigned offset)
>               __raw_writel(__raw_readl(reg) | (1 << offset), reg);
>       }
>  #endif
> +     if (cpu_is_omap24xx() || cpu_is_omap34xx() || cpu_is_omap44xx()) {
> +             u32 ctrl;
> +             if (!bank->mod_usage) {
> +                     ctrl = __raw_readl(bank->base + OMAP24XX_GPIO_CTRL);
> +                     /* Module is enabled, clocks are not gated */
> +                     ctrl &= 0xFFFFFFFE;
> +                     __raw_writel(ctrl, bank->base + OMAP24XX_GPIO_CTRL);
> +             }
> +             bank->mod_usage |= 1 << offset;
> +     }
>       spin_unlock_irqrestore(&bank->lock, flags);
>  
>       return 0;

Here too.


> @@ -1245,6 +1268,16 @@ static void omap_gpio_free(struct gpio_chip *chip, 
> unsigned offset)
>               __raw_writel(1 << offset, reg);
>       }
>  #endif
> +     if (cpu_is_omap24xx() || cpu_is_omap34xx() || cpu_is_omap44xx()) {
> +             u32 ctrl;
> +             bank->mod_usage &= ~(1 << offset);
> +             if (!bank->mod_usage) {
> +                     ctrl = __raw_readl(bank->base + OMAP24XX_GPIO_CTRL);
> +                     /* Module is disabled, clocks are gated */
> +                     ctrl |= 1;
> +                     __raw_writel(ctrl, bank->base + OMAP24XX_GPIO_CTRL);
> +             }
> +     }
>       _reset_gpio(bank, bank->chip.base + offset);
>       spin_unlock_irqrestore(&bank->lock, flags);
>  }

Here too.


> @@ -1879,6 +1912,8 @@ static int __init _omap_gpio_init(void)
>                       gpio_count = 32;
>               }
>  #endif
> +
> +             bank->mod_usage = 0;
>               /* REVISIT eventually switch from OMAP-specific gpio structs
>                * over to the generic ones
>                */
> -- 
> 1.6.0.4
> 
> --
> To unsubscribe from this list: send the line "unsubscribe linux-omap" in
> the body of a message to majord...@vger.kernel.org
> More majordomo info at  http://vger.kernel.org/majordomo-info.html
--
To unsubscribe from this list: send the line "unsubscribe linux-omap" in
the body of a message to majord...@vger.kernel.org
More majordomo info at  http://vger.kernel.org/majordomo-info.html

Reply via email to