From: Rajendra Nayak <rna...@ti.com>
TWL6030 has a formula to be used to calculate the vsel values
to be programmed in the VREG_VOLTAGE registers.
Voltage(in mV) = 1000mv + 100mv * (vsel - 1)
Ex: if vsel = 0x9, mV = 1000 + 100 * (9 -1) = 1800mV.
Signed-off-by: Rajendra Nayak <rna...@ti.com>
Cc: Liam Girdwood <l...@slimlogic.co.uk>
Cc: Samuel Ortiz <sa...@linux.intel.com>
---
drivers/regulator/twl-regulator.c | 23 +++++++++++++++++++----
1 files changed, 19 insertions(+), 4 deletions(-)
diff --git a/drivers/regulator/twl-regulator.c
b/drivers/regulator/twl-regulator.c
index 7e67485..a5ca794 100644
--- a/drivers/regulator/twl-regulator.c
+++ b/drivers/regulator/twl-regulator.c
@@ -367,11 +367,17 @@ twlldo_set_voltage(struct regulator_dev *rdev, int
min_uV, int max_uV)
/* REVISIT for VAUX2, first match may not be best/lowest */
/* use the first in-range value */
- if (min_uV <= uV && uV <= max_uV)
+ if (min_uV <= uV && uV <= max_uV) {
+ if (twl_class_is_6030())
+ /*
+ * Use the below formula to calculate vsel
+ * mV = 1000mv + 100mv * (vsel - 1)
+ */
+ vsel = (mV - 1000)/100 + 1;
return twlreg_write(info, TWL_MODULE_PM_RECEIVER,
VREG_VOLTAGE, vsel);
+ }
}
-
return -EDOM;
}
@@ -384,8 +390,17 @@ static int twlldo_get_voltage(struct regulator_dev *rdev)
if (vsel < 0)
return vsel;
- vsel &= info->table_len - 1;
- return LDO_MV(info->table[vsel]) * 1000;
+ if (twl_class_is_4030()) {
+ vsel &= info->table_len - 1;
+ return LDO_MV(info->table[vsel]) * 1000;
+ } else if (twl_class_is_6030()) {
+ /*
+ * Use the below formula to calculate vsel
+ * mV = 1000mv + 100mv * (vsel - 1)
+ */
+ return (1000 + (100 * (vsel - 1))) * 1000;
+ }
+ return -EDOM;
}
static struct regulator_ops twlldo_ops = {
--
1.6.0.4
--
To unsubscribe from this list: send the line "unsubscribe linux-omap" in
the body of a message to majord...@vger.kernel.org
More majordomo info at http://vger.kernel.org/majordomo-info.html
