- The reset in the driver at init is not needed anymore as the hwmod framework takes care of reseting it. - Reset is removed from omap_i2c_init, which was called not only during probe, but also after time out and error handling. device_reset were added in those places to effect the reset. - Earlier the hwmod SYSC settings were over-written in the driver. Removing the same and letting the hwmod take care of the settings. - Clean up the SYSS_RESETDONE_MASK macro as it is no longer needed. - Clean up the SYSCONFIG SYSC bit defination macros. - Fix the typos in wakeup.
Signed-off-by: Shubhrajyoti D <shubhrajy...@ti.com> --- drivers/i2c/busses/i2c-omap.c | 82 +++++++++++------------------------------ 1 files changed, 22 insertions(+), 60 deletions(-) diff --git a/drivers/i2c/busses/i2c-omap.c b/drivers/i2c/busses/i2c-omap.c index fa23faa..beff9f3 100644 --- a/drivers/i2c/busses/i2c-omap.c +++ b/drivers/i2c/busses/i2c-omap.c @@ -155,19 +155,6 @@ enum { #define OMAP_I2C_SYSTEST_SDA_O (1 << 0) /* SDA line drive out */ #endif -/* OCP_SYSSTATUS bit definitions */ -#define SYSS_RESETDONE_MASK (1 << 0) - -/* OCP_SYSCONFIG bit definitions */ -#define SYSC_CLOCKACTIVITY_MASK (0x3 << 8) -#define SYSC_SIDLEMODE_MASK (0x3 << 3) -#define SYSC_ENAWAKEUP_MASK (1 << 2) -#define SYSC_SOFTRESET_MASK (1 << 1) -#define SYSC_AUTOIDLE_MASK (1 << 0) - -#define SYSC_IDLEMODE_SMART 0x2 -#define SYSC_CLOCKACTIVITY_FCLK 0x2 - /* Errata definitions */ #define I2C_OMAP_ERRATA_I207 (1 << 0) #define I2C_OMAP3_1P153 (1 << 1) @@ -182,6 +169,7 @@ struct omap_i2c_dev { u32 latency; /* maximum mpu wkup latency */ void (*set_mpu_wkup_lat)(struct device *dev, long latency); + int (*device_reset)(struct device *dev); u32 speed; /* Speed of bus in Khz */ u16 cmd_err; u8 *buf; @@ -317,60 +305,23 @@ static int omap_i2c_init(struct omap_i2c_dev *dev) u16 psc = 0, scll = 0, sclh = 0, buf = 0; u16 fsscll = 0, fssclh = 0, hsscll = 0, hssclh = 0; unsigned long fclk_rate = 12000000; - unsigned long timeout; unsigned long internal_clk = 0; struct clk *fclk; struct omap_i2c_bus_platform_data *pdata; pdata = dev->dev->platform_data; - if (dev->rev >= OMAP_I2C_OMAP1_REV_2) { - /* Disable I2C controller before soft reset */ - omap_i2c_write_reg(dev, OMAP_I2C_CON_REG, - omap_i2c_read_reg(dev, OMAP_I2C_CON_REG) & - ~(OMAP_I2C_CON_EN)); - - omap_i2c_write_reg(dev, OMAP_I2C_SYSC_REG, SYSC_SOFTRESET_MASK); - /* For some reason we need to set the EN bit before the - * reset done bit gets set. */ - timeout = jiffies + OMAP_I2C_TIMEOUT; - omap_i2c_write_reg(dev, OMAP_I2C_CON_REG, OMAP_I2C_CON_EN); - while (!(omap_i2c_read_reg(dev, OMAP_I2C_SYSS_REG) & - SYSS_RESETDONE_MASK)) { - if (time_after(jiffies, timeout)) { - dev_warn(dev->dev, "timeout waiting " - "for controller reset\n"); - return -ETIMEDOUT; - } - msleep(1); - } - - /* SYSC register is cleared by the reset; rewrite it */ - if (dev->rev == OMAP_I2C_REV_ON_2430) { - - omap_i2c_write_reg(dev, OMAP_I2C_SYSC_REG, - SYSC_AUTOIDLE_MASK); - - } else if (dev->rev >= OMAP_I2C_REV_ON_3430) { - dev->syscstate = SYSC_AUTOIDLE_MASK; - dev->syscstate |= SYSC_ENAWAKEUP_MASK; - dev->syscstate |= (SYSC_IDLEMODE_SMART << - __ffs(SYSC_SIDLEMODE_MASK)); - dev->syscstate |= (SYSC_CLOCKACTIVITY_FCLK << - __ffs(SYSC_CLOCKACTIVITY_MASK)); - - omap_i2c_write_reg(dev, OMAP_I2C_SYSC_REG, - dev->syscstate); - /* - * Enabling all wakup sources to stop I2C freezing on - * WFI instruction. - * REVISIT: Some wkup sources might not be needed. - */ - dev->westate = OMAP_I2C_WE_ALL; - omap_i2c_write_reg(dev, OMAP_I2C_WE_REG, - dev->westate); - } + if (dev->rev >= OMAP_I2C_REV_ON_3430) { + /* + * Enabling all wakeup sources to stop I2C freezing on + * WFI instruction. + * REVISIT: Some wakeup sources might not be needed. + */ + dev->westate = OMAP_I2C_WE_ALL; + omap_i2c_write_reg(dev, OMAP_I2C_WE_REG, + dev->westate); } + omap_i2c_write_reg(dev, OMAP_I2C_CON_REG, 0); if (pdata->flags & OMAP_I2C_FLAG_ALWAYS_ARMXOR_CLK) { @@ -594,6 +545,11 @@ static int omap_i2c_xfer_msg(struct i2c_adapter *adap, return r; if (r == 0) { dev_err(dev->dev, "controller timed out\n"); + if (dev->device_reset) { + r = dev->device_reset(dev->dev); + if (r < 0) + dev_err(dev->dev, "reset failed\n"); + } omap_i2c_init(dev); return -ETIMEDOUT; } @@ -604,6 +560,11 @@ static int omap_i2c_xfer_msg(struct i2c_adapter *adap, /* We have an error */ if (dev->cmd_err & (OMAP_I2C_STAT_AL | OMAP_I2C_STAT_ROVR | OMAP_I2C_STAT_XUDF)) { + if (dev->device_reset) { + r = dev->device_reset(dev->dev); + if (r < 0) + dev_err(dev->dev, "reset failed\n"); + } omap_i2c_init(dev); return -EIO; } @@ -1004,6 +965,7 @@ omap_i2c_probe(struct platform_device *pdev) if (pdata != NULL) { speed = pdata->clkrate; dev->set_mpu_wkup_lat = pdata->set_mpu_wkup_lat; + dev->device_reset = pdata->device_reset; } else { speed = 100; /* Default speed */ dev->set_mpu_wkup_lat = NULL; -- 1.7.1 -- To unsubscribe from this list: send the line "unsubscribe linux-omap" in the body of a message to majord...@vger.kernel.org More majordomo info at http://vger.kernel.org/majordomo-info.html