On Wednesday 08 August 2012 02:18 PM, Tomi Valkeinen wrote:
On Wed, 2012-08-08 at 14:08 +0530, Archit Taneja wrote:
On Wednesday 08 August 2012 01:43 PM, Tomi Valkeinen wrote:
On Wed, 2012-08-08 at 13:29 +0530, Archit Taneja wrote:
Okay, one thing which I want to align on is that most of these functions
don't really do the actual configurations. That is, they'll just update
the private data, and the actual configuration will only happen on enable.
We would want set_timings() op to have a direct impact. But we wouldn't
want the same for setting the data lines, that could be clubbed with
other configurations at enable. That's okay, right?
I'm not sure we want/need set_timings to have direct impact. Changing
the timings on the fly has some problems, like the output size changing
to smaller than the overlays, and we perhaps may need to adjust the
clock dividers (dispc's, DSI PLL's or PRCM's).
It feels just much easier and safer to require that the mgr is disabled
when these changes are made. And as far as I can see, there shouldn't be
any need to change the timings via the shadow registers, as quickly as
possible and during vblank...
That makes sense. But currently set_timings for DPI has a direct impact.
HDMI/VENC/SDI take the easier route of disabling and enabling the interface.
I agree it's safer and easier to make sure things are disabled first,
but maybe it's good to have the capability set hdmi timings on the fly
in the future, it would make the switch faster, same goes for reading edid.
When do we need to switch mode quickly? Reading edid should not require
disabling the output for sure.
I think I'm just finding excuses to find a use for my work done in
APPLYing manager related registers.
You are right about edid. Changing HDMI timings take a couple of seconds
now, I was wondering how much that has to do with us completely
disabling/enabling hdmi. it may be just the slowness of the monitors
which causes this.
HDMI is a bit broken currently, though. I think we first enable the
whole stuff, including video output using VGA, then we read EDID, then
we change the mode.
We should just enable enough of HDMI to be able to read EDID, and start
the video output with the correct mode. This needs some restructuring of
the driver, though. I tried it once quickly, but it turned out not to be
trivial.
Right. Most likely this restructuring would allow us to modify only the
hdmi timings part when setting a new timing. We could check how much
time we save then :)
What I meant to ask was whether we should do the same for something like
dpi_set_data_lines(), that is, disable dpi, update the data_lines
private data with a new value, and enable dpi again.
Hmm, I think it's better to leave disabling and enabling the output to
the panel driver. So when the panel driver wants to use
dpi_set_data_lines(), it needs to first disable the DPI output. If it
doesn't, dpi_set_data_lines() returns -EBUSY.
Otherwise if the panel driver does something like:
dpi_set_foo()
dpi_set_bar()
Both of those could first disable output, change setting, enable output.
Instead the panel should first disable, then call those, and then
enable.
Right, that makes sense.
Archit
--
To unsubscribe from this list: send the line "unsubscribe linux-omap" in
the body of a message to majord...@vger.kernel.org
More majordomo info at http://vger.kernel.org/majordomo-info.html
