On Sat, Aug 18, 2012 at 12:22:29AM +0530, Venkatraman S wrote:
> omap hsmmc controller IP has an inbuilt timer that can be programmed to
^^^^^^^
built-in
> guard against unresponsive operations. But it's range is very narrow,
^^^^
its
> and it's maximum countable time is a few seconds.
^^^^
its
> Card maintenance operations like BKOPS and SECURE DISCARD and long
> stream writes like packed command require timers of order of
> several minutes.
> So get rid of using the IP timer entirely and use kernel's hrtimer
> functionality for guarding the device operations.
> As part of this change, a workaround that disabled timeouts for
> MMC_ERASE commands is removed, and the arbitary timing of 100ms
> is used only when the timeout is not explicitly specified by core.
>
> Signed-off-by: Venkatraman S <svenk...@ti.com>
> ---
> drivers/mmc/host/omap_hsmmc.c | 96
> ++++++++++++++++++++++---------------------
> 1 file changed, 50 insertions(+), 46 deletions(-)
>
> diff --git a/drivers/mmc/host/omap_hsmmc.c b/drivers/mmc/host/omap_hsmmc.c
> index 9afdd20..8f7cebc 100644
> --- a/drivers/mmc/host/omap_hsmmc.c
> +++ b/drivers/mmc/host/omap_hsmmc.c
> @@ -79,7 +79,7 @@
> #define CLKD_SHIFT 6
> #define DTO_MASK 0x000F0000
> #define DTO_SHIFT 16
> -#define INT_EN_MASK 0x307F0033
> +#define INT_EN_MASK 0x306E0033
not related to this patch in particular, but it would be nice if this
was converted to something more meaningfull, like ORing a bunch of bit
defines.
> #define BWR_ENABLE (1 << 4)
> #define BRR_ENABLE (1 << 5)
> #define DTO_ENABLE (1 << 20)
> @@ -160,6 +160,7 @@ struct omap_hsmmc_host {
> unsigned int dma_sg_idx;
> unsigned char bus_mode;
> unsigned char power_mode;
> + unsigned int ns_per_clk_cycle;
> int suspended;
> int irq;
> int use_dma, dma_ch;
> @@ -172,6 +173,7 @@ struct omap_hsmmc_host {
> int reqs_blocked;
> int use_reg;
> int req_in_progress;
> + struct hrtimer guard_timer;
> struct omap_hsmmc_next next_data;
>
> struct omap_mmc_platform_data *pdata;
> @@ -455,10 +457,6 @@ static void omap_hsmmc_enable_irq(struct omap_hsmmc_host
> *host,
> else
> irq_mask = INT_EN_MASK;
>
> - /* Disable timeout for erases */
> - if (cmd->opcode == MMC_ERASE)
> - irq_mask &= ~DTO_ENABLE;
> -
> OMAP_HSMMC_WRITE(host->base, STAT, STAT_CLEAR);
> OMAP_HSMMC_WRITE(host->base, ISE, irq_mask);
> OMAP_HSMMC_WRITE(host->base, IE, irq_mask);
> @@ -508,6 +506,9 @@ static void omap_hsmmc_set_clock(struct omap_hsmmc_host
> *host)
> && time_before(jiffies, timeout))
> cpu_relax();
>
> + if (ios->clock)
> + host->ns_per_clk_cycle = DIV_ROUND_UP(NSEC_PER_SEC, ios->clock);
> +
> omap_hsmmc_start_clock(host);
> }
>
> @@ -824,7 +825,7 @@ omap_hsmmc_xfer_done(struct omap_hsmmc_host *host, struct
> mmc_data *data)
> omap_hsmmc_request_done(host, mrq);
> return;
> }
> -
> + hrtimer_cancel(&host->guard_timer);
> host->data = NULL;
>
> if (!data->error)
> @@ -859,8 +860,11 @@ omap_hsmmc_cmd_done(struct omap_hsmmc_host *host, struct
> mmc_command *cmd)
> cmd->resp[0] = OMAP_HSMMC_READ(host->base, RSP10);
> }
> }
> - if ((host->data == NULL && !host->response_busy) || cmd->error)
> + if ((host->data == NULL && !host->response_busy) || cmd->error) {
could just go ahead and make this check uniform by:
if ((!host->data && !host->response_busy)) || cmd->error)
> + if (cmd->error != -ETIMEDOUT)
> + hrtimer_cancel(&host->guard_timer);
> omap_hsmmc_request_done(host, cmd->mrq);
> + }
> }
>
> /*
> @@ -992,7 +996,7 @@ static void omap_hsmmc_do_irq(struct omap_hsmmc_host
> *host, int status)
> hsmmc_command_incomplete(host, -EILSEQ);
>
> end_cmd = 1;
> - if (host->data || host->response_busy) {
> + if (data || host->response_busy) {
This doesn't seem like it belongs to $SUBJECT...
> end_trans = 1;
> host->response_busy = 0;
> }
> @@ -1292,41 +1296,35 @@ static int omap_hsmmc_start_dma_transfer(struct
> omap_hsmmc_host *host,
> return 0;
> }
>
> -static void set_data_timeout(struct omap_hsmmc_host *host,
> - unsigned int timeout_ns,
> - unsigned int timeout_clks)
> +static void set_guard_timer(struct omap_hsmmc_host *host,
> + unsigned long timeout_ms, unsigned long timeout_ns,
> + unsigned int timeout_clks)
> {
> - unsigned int timeout, cycle_ns;
> - uint32_t reg, clkd, dto = 0;
> + ktime_t gtime;
> + unsigned int sec, nsec;
>
> - reg = OMAP_HSMMC_READ(host->base, SYSCTL);
> - clkd = (reg & CLKD_MASK) >> CLKD_SHIFT;
> - if (clkd == 0)
> - clkd = 1;
> + sec = timeout_ms / MSEC_PER_SEC;
> + nsec = (timeout_ms % MSEC_PER_SEC) * NSEC_PER_MSEC + timeout_ns;
>
> - cycle_ns = 1000000000 / (clk_get_rate(host->fclk) / clkd);
> - timeout = timeout_ns / cycle_ns;
> - timeout += timeout_clks;
> - if (timeout) {
> - while ((timeout & 0x80000000) == 0) {
> - dto += 1;
> - timeout <<= 1;
> - }
> - dto = 31 - dto;
> - timeout <<= 1;
> - if (timeout && dto)
> - dto += 1;
> - if (dto >= 13)
> - dto -= 13;
> - else
> - dto = 0;
> - if (dto > 14)
> - dto = 14;
> - }
> + nsec += timeout_clks * host->ns_per_clk_cycle;
> + gtime = ktime_set(sec, nsec);
>
> - reg &= ~DTO_MASK;
> - reg |= dto << DTO_SHIFT;
> - OMAP_HSMMC_WRITE(host->base, SYSCTL, reg);
> + hrtimer_start(&host->guard_timer, gtime, HRTIMER_MODE_REL);
> +}
> +
> +enum hrtimer_restart omap_hsmmc_timedout(struct hrtimer *gtimer)
static ?
--
balbi
signature.asc
Description: Digital signature
