RACEN bit should only be set if the voltage and command register addresses
are the same.
Signed-off-by: Tero Kristo <t-kri...@ti.com>
---
arch/arm/mach-omap2/vc.c | 5 ++++-
1 files changed, 4 insertions(+), 1 deletions(-)
diff --git a/arch/arm/mach-omap2/vc.c b/arch/arm/mach-omap2/vc.c
index 2ca00bc..a63c53a 100644
--- a/arch/arm/mach-omap2/vc.c
+++ b/arch/arm/mach-omap2/vc.c
@@ -695,9 +695,12 @@ void __init omap_vc_init_channel(struct voltagedomain
*voltdm)
voltdm->rmw(vc->smps_cmdra_mask,
vc->cmd_reg_addr << __ffs(vc->smps_cmdra_mask),
vc->smps_cmdra_reg);
- vc->cfg_channel |= vc_cfg_bits->rac | vc_cfg_bits->racen;
+ vc->cfg_channel |= vc_cfg_bits->rac;
}
+ if (vc->cmd_reg_addr == vc->volt_reg_addr)
+ vc->cfg_channel |= vc_cfg_bits->racen;
+
/* Set up the on, inactive, retention and off voltage */
on_vsel = omap_vc_calc_vsel(voltdm, voltdm->vc_param->on);
onlp_vsel = omap_vc_calc_vsel(voltdm, voltdm->vc_param->onlp);
--
1.7.4.1
--
To unsubscribe from this list: send the line "unsubscribe linux-omap" in
the body of a message to majord...@vger.kernel.org
More majordomo info at http://vger.kernel.org/majordomo-info.html
