On 01/03/2018 07:48 PM, [email protected] wrote:
On Wed, 3 Jan 2018, Patrick Boutilier wrote:Did you try using the Ctrl-R interface during boot instead of MegaCLI after boot? I have always had success importing foreign configs that way.Hi Patrick, No, I did not try that. I'll do on the next iteration (tonight).Would storcli have worked any better? Perhaps that'd be a reason to ditch megacli since it has not been updated in ages..Rebooting a host to import RAID LD's in a hot-swap config is quite a pain, IMHO. This worked just fine for me in the past using LSI HBA's (9271-8i) but it seems these PERC are a little more touchy..Vincent
Oh, didn't realize Server 2 was booted when you moved drives over. Not sure about storcli but there is a perccli from 2015 available from Dell. Might be able to do something with that.
[root@vs07 plugins]# /opt/MegaRAID/perccli/perccli64 -v
PercCli SAS Customization Utility Ver 1.17.10 October 21, 2015
(c)Copyright 2015, AVAGO Corporation, All Rights Reserved.
Exit Code: 0x00
[root@vs07 plugins]# rpm -qf /opt/MegaRAID/perccli/perccli64
perccli-1.17.10-1.noarch
<<attachment: boutilpj.vcf>>
_______________________________________________ Linux-PowerEdge mailing list [email protected] https://lists.us.dell.com/mailman/listinfo/linux-poweredge
