Hi Chris,

That's right, I should have given more info :
---------------------------------------------------------
# ls /proc/rd
c0/  status      
# cat /proc/rd/status
OK
# ls /proc/rd/c0
current_status  initial_status  user_command
# cat /proc/rd/c0/current_status
*** DAC960 RAID Driver Version 2.2.9 of 7 September 2000 ***
Copyright 1998-2000 by Leonard N. Zubkoff <[EMAIL PROTECTED]>
Configuring Mylex AcceleRAID 170 PCI RAID Controller
Firmware Version: 6.00-01, Channels: 1, Memory Size: 32MB
PCI Bus: 2, Device: 5, Function: 1, I/O Address: Unassigned
PCI Address: 0xE6EFE000 mapped at 0xD0800000, IRQ Channel: 10
Controller Queue Depth: 512, Maximum Blocks per Command: 2048
Driver Queue Depth: 511, Scatter/Gather Limit: 128 of 257 Segments
  Physical Devices:
    0:1  Vendor: SEAGATE   Model: ST318436LC   Revision: 0010
         Wide Synchronous at 160 MB/sec
         Disk Status: Online, 35852288 blocks
    0:2  Vendor: SEAGATE   Model: ST318436LC   Revision: 0010
         Wide Synchronous at 160 MB/sec
         Disk Status: Online, 35852288 blocks
    0:3  Vendor: SEAGATE   Model: ST318436LC   Revision: 0010
         Wide Synchronous at 160 MB/sec
         Disk Status: Online, 35852288 blocks
    0:4  Vendor: SEAGATE   Model: ST318436LC   Revision: 0010
         Wide Synchronous at 160 MB/sec
         Disk Status: Online, 35852288 blocks
    0:5  Vendor: SEAGATE   Model: ST318436LC   Revision: 0010
         Wide Synchronous at 160 MB/sec
         Disk Status: Online, 35852288 blocks
    0:7  Vendor: MYLEX  Model: AcceleRAID 170  Revision: 0600
         Wide Synchronous at 160 MB/sec
  Logical Drives:
    /dev/rd/c0d0: RAID-5, Online, 143409152 blocks
            Logical Device Initialized, BIOS Geometry: 255/63
            Stripe Size: 64KB, Segment Size: 8KB
            Read Cache Disabled, Write Cache Disabled
No Rebuild or Consistency Check in
Progress                                                                               
                                                                                       
  
-----------------------------------------------------------


The initial_status file is identical (good :-).


* A note about the temperatures : they are correct.
* Nothing in the log files that could give me a clue on the crash.

Thanks for helping.

-
To unsubscribe from this list: send the line "unsubscribe linux-raid" in
the body of a message to [EMAIL PROTECTED]

Reply via email to