Hello All , Is there a documented procedure to follow during
creation or after that will get a raid6 array to self
rebuild ?
Why I am asking .
I was getting the errors below at a heavy rate , so ...
Sep 7 20:11:49 localhost kernel: scsi2 (2:0): rejecting I/O to dead
device
Sep 7 20:11:49 localhost kernel: md: write_disk_sb failed for device
sde
Sep 7 20:11:49 localhost kernel: md: excessive errors occurred during
superblock update, exiting
Sep 7 20:11:49 localhost kernel: raid5: Disk failure on sde,
disabling device. Operation continuing on 35 devices
I ran the below & the above messages stopped . But the array
(appears to have) never tried rebuilding .
# mdadm --manage --fail /dev/md_d0 /dev/sde
The problem arose because the drive died totally . ie:
[EMAIL PROTECTED]:/ # fdisk /dev/sde
Unable to open /dev/sde
# cat /proc/mdstat
...snip...
md_d0 : active raid5 sdc[0] sdao[40] sdan[34] sdam[33] sdal[32]
sdak[31] sdaj[30] sdah[29] sdag[28] sdaf[27] sdae[26] sdad[25]
sdac[24] sdab[23] sdaa[22] sdz[21] sdy[20] sdw[19] sdv[18] sdu[17]
sdt[16] sds[15] sdr[14] sdq[13] sdp[12] sdo[11] sdn[10] sdl[9] sdk[8]
sdj[7] sdi[6] sdh[5] sdg[4] sdf[3] sde[2](F) sdd[1]
1244826240 blocks level 5, 64k chunk, algorithm 2 [36/35]
[UU_UUUUUUUUUUUUUUUUUUUUUUUUUUUUUUUUU]
...snip...
# cat /etc/mdadm.conf
DEV /dev/sd[c-l] /dev/sd[n-w] /dev/sd[yz] /dev/sda[a-h] /dev/sda[j-s]
ARRAY /dev/md_d0 level=raid5 num-devices=36 spares=4
UUID=2006d8c6:71918820:247e00b0:460d5bc1
--
+------------------------------------------------------------------+
| James W. Laferriere | System Techniques | Give me VMS |
| Network Engineer | 3542 Broken Yoke Dr. | Give me Linux |
| [EMAIL PROTECTED] | Billings , MT. 59105 | only on AXP |
+------------------------------------------------------------------+
-
To unsubscribe from this list: send the line "unsubscribe linux-raid" in
the body of a message to [EMAIL PROTECTED]
More majordomo info at http://vger.kernel.org/majordomo-info.html
