On Sunday February 25, [EMAIL PROTECTED] wrote: > Anyone have a good explanation for the use of bitmaps? > > Anyone on the list use them? > > http://gentoo-wiki.com/HOWTO_Gentoo_Install_on_Software_RAID#Data_Scrubbing > > Provides an explanation on that page. > > I believe Neil stated that using bitmaps does incur a 10% performance > penalty. If one's box never (or rarely) crashes, is a bitmap needed?
I think I said it "can" incur such a penalty. The actual cost is very dependant on work-load. > > The one question I had regarding a bitmap is as follows: > > The mismatch_cnt file. > > If I have bitmaps turned on for my RAID DEVICES, is it possible that the > 'mismatch_cnt' will be updated when it finds a bad block? > > That would be VERY nice instead of running a check all the time. When md find a bad block (read failure) it either fixes it (by successfully over-writing the correct date) or fails the drive. The count of the times that this has happened is available via /sys/block/mdX/md/errors If you use version-1 superblocks, then this count is maintained throughout the life of the array. If you use v0.90, the count is zeroed whenever you assemble the array. This count is completely separate from the 'mismatch_cnt'. 'mismatch_cnt' referred to when md check if redundant information (copies or parity) is consistent or not. This does not happen at all during normal operation. It only happens when you ask for a 'check' or 'repair' operation. It might also happen when the array automatically performs a 'sync' after an unclean shutdown. And all this has very little to do with bitmaps. So I'm afraid I don't understand your question. NeilBrown - To unsubscribe from this list: send the line "unsubscribe linux-raid" in the body of a message to [EMAIL PROTECTED] More majordomo info at http://vger.kernel.org/majordomo-info.html
