Tomasz, On Wed, Dec 11, 2013 at 4:13 PM, Tomasz Figa <tomasz.f...@gmail.com> wrote: > 2013/12/12 Doug Anderson <diand...@chromium.org>: >> This does match what's done in exynos4 and exynos5420 and it's not >> terrible. I'm always a fan of actually specifying clocks properly and >> that's more possible now using the syscon stuff (see Leela Krishna's >> watchdog patches). You'd have to extend that to add a clock, but that >> wouldn't be too hard. > > Leela's patches are about PMU, not sysreg, but that's not an issue, I guess, > as it's about adding a clock to the generic syscon driver.
Right. I was proposing doing something similar to his, but for the separate "sysreg" address range. ...then adding a clock to the generic syscon driver. I _think_ the syscon clock doesn't really need to be always on--it only needs to be on during the access of these registers, right? I make this statement based on the fact that exynos5250 boards currently bootup and are very functional, but this clock is currently off. > Still, I discussed about such cases as this with Sylwester a bit today and > maybe a bit different approach would be better. There is a number of clocks > that need to be always on, such as PMU (but also a lot of currently undefined > ones). IMHO it would be nice to make sure they are enabled at boot time > and do one of following: > 1) claim and enable them directly from the clock controller driver > 2) define them with CLK_IGNORE_UNUSED flag and enable them directly from > the clock controller driver (without increasing the refcount, so users > could > possibly disable them later), > 3) add a generic flag, such as CLK_BOOT_ENABLE (or something), that would > make the CCF enable such clock at bootup (in addition to implying > CLK_IGNORE_UNUSED). > > For me, the most sensible option would be 2) as it doesn't bloat the CCF with > yet another flag and doesn't encourage people to leave clocks always on > just because of laziness stopping them from implementing proper clock > support in drivers. Right, we're using #2 for this now, but one problem is that it's possible that the firmware may turn off one of these misc-type clocks. On exynos5250-snow we ran into this. The firmware actually gates the clock needed for accessing the chip_id, though perhaps that's not one of the clocks that needs to be on all the time. -Doug -- To unsubscribe from this list: send the line "unsubscribe linux-samsung-soc" in the body of a message to majord...@vger.kernel.org More majordomo info at http://vger.kernel.org/majordomo-info.html