-----BEGIN PGP SIGNED MESSAGE----- Hash: SHA1 I meet the usb problem in Linux 3.13-rc8, in my board, the HSIC in SoC is connect to usb4640, I have using a litter driver to reset usb4640 after boot. In the old time, when it doesn't use common phy framework, it was work. In board, the otg is brike(maybe by franklinism) but HSIC of host is normal, I have tested. the dmesg show that [ 1.260000] samsung-usb2phy 125b0000.usbphy: Can't get usb-phy sysreg cfg register [ 1.300000] usbcore: registered new interface driver uvcvideo [ 1.440000] usbcore: registered new interface driver usbhid [ 1.440000] usbhid: USB HID core driver [ 1.475000] samsung-usb2phy 125b0000.usbphy: Can't configure specified phy mode specified phy mode
root@kagami:~# lsusb Bus 001 Device 001: ID 1d6b:0002 Linux Foundation 2.0 root hub ==================dts======================== /* * Hardkernel's Exynos4412 based tiny4412 1306 board device tree source * * Copyright (c) 2013 Tomoya Gitsufuki <ay...@mail.soulik.info> * * Device tree source file for Friendyarm tiny4412 1306 board which is based on * Samsung's Exynos4412 SoC. * * This program is free software; you can redistribute it and/or modify * it under the terms of the GNU General Public License version 2 as * published by the Free Software Foundation. */ /dts-v1/; #include "exynos4412.dtsi" / { model = "Friendly Arm Tiny4412 1306 board based on Exynos4412"; compatible = "friendlyarm,tiny4412-1306", "samsung,exynos4412"; memory { reg = <0x40000000 0x40000000>; }; chosen { bootargs ="root=/dev/mmcblk0p1 rootfstype=ext4 rw console=ttySAC0,115200 init=/sbin/init"; }; leds { compatible = "gpio-leds"; led1 { label = "led1:heart"; gpios = <&gpm4 0 1>; default-state = "on"; linux,default-trigger = "heartbeat"; }; led2 { label = "led2:mmc0"; gpios = <&gpm4 1 1>; default-state = "on"; linux,default-trigger = "mmc0"; }; }; regulators { compatible = "simple-bus"; #address-cells = <1>; vemmc_reg: regulator-0 { compatible = "regulator-fixed"; regulator-name = "VMEM_VDD_2.8V"; regulator-min-microvolt = <2800000>; regulator-max-microvolt = <2800000>; gpio = <&gpk0 2 0>; enable-active-high; }; }; mshc@12550000 { num-slots = <1>; supports-highspeed; /*vmmc-supply = <&vemmc_reg>;*/ broken-cd; non-removable; card-detect-delay = <200>; samsung,dw-mshc-ciu-div = <3>; samsung,dw-mshc-sdr-timing = <2 3>; samsung,dw-mshc-ddr-timing = <1 2>; pinctrl-0 = <&sd4_clk &sd4_cmd &sd4_bus4 &sd4_bus8>; pinctrl-names = "default"; status = "okay"; slot@0 { reg = <0>; bus-width = <8>; }; }; rtc@10070000 { status = "okay"; }; sdhci@12530000 { bus-width = <4>; pinctrl-0 = <&sd2_clk &sd2_cmd &sd2_bus4 &sd2_cd>; pinctrl-names = "default"; status = "okay"; }; sdhci@1254000 { bus-width = <4>; pinctrl-0 = <&sd3_clk &sd3_cmd &sd3_bus4 &sd3_cd>; pinctrl-names = "default"; status = "okay"; }; usb4640 { compatible = "smsc,usb4640"; reset-gpios = <&gpm2 4 1>; }; usb_phy: usbphy@125B0000 { #address-cells = <1>; #size-cells = <1>; compatible = "samsung,exynos4210-usb2phy"; reg = <0x125B0000 0x100>; ranges; status = "okay"; clocks = <&clock 2>, <&clock 305>; clock-names = "xusbxti", "otg"; usbphy-sys { /* USB device and host PHY_CONTROL registers */ reg = <0x10020704 0x8>; }; }; ehci@12580000 { usb-phy = <&usb_phy>; status = "okay"; }; codec@13400000 { samsung,mfc-r = <0x43000000 0x800000>; samsung,mfc-l = <0x51000000 0x800000>; status = "okay"; }; serial@13800000 { status = "okay"; }; serial@13810000 { status = "okay"; }; serial@13820000 { status = "okay"; }; serial@13830000 { status = "okay"; }; fixed-rate-clocks { xxti { compatible = "samsung,clock-xxti"; clock-frequency = <0>; }; xusbxti { compatible = "samsung,clock-xusbxti"; clock-frequency = <24000000>; }; }; i2c@13860000 { status = "okay"; samsung,i2c-sda-delay = <100>; samsung,i2c-max-bus-freq = <200000>; wm8960@10 { compatible = "wlf,wm8960"; reg = <0x10>; }; }; }; =================end dts====================== Thank you ayaka -----BEGIN PGP SIGNATURE----- Version: GnuPG v1.4.12 (GNU/Linux) Comment: Using GnuPG with Mozilla - http://enigmail.mozdev.org/ iQEcBAEBAgAGBQJS1maOAAoJEPb4VsMIzTzil+sH/0vyYQLE1UVkchPkGPf5z0Xj zSjry3FqsJOdoEV2551V+MlXwUc+KzfmZ/T6oZShq2Uywa+C3zuw+fMAurf1JKxm ogFAv816ncFeMRud+2mmSuN9J4oAZ99sYMQ57W0t0o4+lRJm7ASfM6S00IxLNxjb Kyv+5yhGn9HH08FcTM+3kMSMkcBgka6/ojtS0249tva5IcweR0TSSJqmYPDGePjE x256eHyi39357VcaI9pUhuGl1ZkA2arRbRGgkE1bjG8SAqAMpcy7t/cLs4LVjiU/ qsz0po0LMvtXZJ0gC4ktmPN0Z4BjPuxMqXHqnvlYT3q8e+BhrvZkTphS57DsNIk= =0Iaw -----END PGP SIGNATURE----- -- To unsubscribe from this list: send the line "unsubscribe linux-samsung-soc" in the body of a message to majord...@vger.kernel.org More majordomo info at http://vger.kernel.org/majordomo-info.html