I found this in a diagnostic dump, maybe someone can make any sense of it? [76]: CT_FindMissingEntry: dev = 3 [77]: CT_SwitchFillPrimary: recover missing entry, container Inde [78]: x 1, dev 3, signature 0xf7b74944 [79]: CT_CONFIG_WARNING: at Line 8983 - CFG_MISSING_PARTITION: ar [80]: g1 = 0x2 arg2 = 0x0
Kit > -----Oorspronkelijk bericht----- > Van: Kit Gerrits [mailto:[EMAIL PROTECTED] > Verzonden: maandag 31 januari 2005 14:49 > Aan: linux-scsi@vger.kernel.org > Onderwerp: PERC2/Si won't failover > > Hey all! > > I have a PowerEDGE 2400 with PERC2/Si with 4x9GB Drives with > RedHat EL 3.0 Container 0: plain 9GB drive (O/S) Container 1: > 3x9GB in RAID5 (data) > > After getting I/O Errors (and gettinge a strange noise from > drive 0:3:0), I did the unthinkable: I pulled the drive from > the chassis without shutting it down. (oops) I have now > verified the drive, cleaned off the partition and rescanned the bus. > ...but the drive won't failover > > I have set it to failover, but the PERC won't failover the > drive, even after a (warm) reboot. > > Did I forget anything? > > Thanks in advance, > > Kit Gerrits > [EMAIL PROTECTED] > > > --------------- > Debugging info: > --------------- > > AFA0> disk list > Executing: disk list > > B:ID:L Device Type Blocks Bytes/Block Usage > Shared Rate > ------ -------------- --------- ----------- > ---------------- ------ ---- > 0:00:0 Disk 17783240 512 Initialized > NO 80 > 0:01:0 Disk 17783240 512 Initialized > NO 80 > 0:02:0 Disk 17783240 512 Initialized > NO 80 > 0:03:0 Disk 17783240 512 Initialized > NO 80 > > AFA0> container show failover > Executing: container show failover > > Container Scsi B:ID:L > --------- ---------------------------------- > 0 --- No Devices Assigned --- > 1 0:03:0 > > AFA0> container list > Executing: container list > Num Total Oth Chunk Scsi Partition > Label Type Size Ctr Size Usage B:ID:L Offset:Size > ----- ------ ------ --- ------ ------- ------ ------------- > 0 Volume 8.47GB Open 0:00:0 64.0KB:8.47GB > /dev/sda NT > > 1 RAID-5 16.9GB 32KB Open 0:01:0 64.0KB:8.47GB > /dev/sdb DATA 0:02:0 64.0KB:8.47GB > ?:??:? - Missing - > > AFA0> controller show au > Executing: controller show automatic_failover Automatic > failover ENABLED > > AFA0> container scrub 1 > Executing: container scrub 1 > Command Error: <The controller was unable to perform a scrub > (consistency > check) > operation on the container because one or more of the > container's partitions fa iled. > > > - To unsubscribe from this list: send the line "unsubscribe linux-scsi" in the body of a message to [EMAIL PROTECTED] More majordomo info at http://vger.kernel.org/majordomo-info.html