Hi Here is an ia64 box with a QLogic QLA12160 PCI to SCSI Host Adapter and two SCSI disks.
One of them is a SEAGATE ST318453LC (18352 MB) the other one is a SEAGATE ST3146807LC (147GB). The ST3146807LC disk works fine in other boxes. I just put it into this one from a HP server where it was working with the *same* controller. In this box I get the following error message: sd 0:0:2:0: [sdb] READ CAPACITY failed sd 0:0:2:0: [sdb] Result: hostbyte=0x00 driverbyte=0x08 sd 0:0:2:0: [sdb] Sense Key : 0x3 [current] sd 0:0:2:0: [sdb] ASC=0x31 ASCQ=0x0 sd 0:0:2:0: [sdb] Write Protect is off sd 0:0:2:0: [sdb] Mode Sense: ab 00 10 08 sd 0:0:2:0: [sdb] Write cache: enabled, read cache: enabled, supports DPO and FU A sd 0:0:2:0: [sdb] Attached SCSI disk I am currently running 2.6.22 but I've also tried with serveral other (and older) kernels and it still can't get the capacity of the disk. The other disk ST318453LC is just working fine and it is serving as the system disk. The only thing I can do is to run scsiformat(8) which finishes correctly. I've also tried to fill the disk with zeroes using dd(1) but that did not help anything either. The full dmesg of the box can be found at http://humppa.hu/dmesg.scsi EFI information: Seg: 1 Bus: 0 Dev: 3 Func: 0 - Qlogic 12160 SCSI Controller detected: Firmware Rev 6 (Pun 1,Lun 0): SEAGATE ST318453LC 0002 (Pun 2,Lun 0): SEAGATE ST3146807LC 0003 Do you guys have any idea? Thanks - To unsubscribe from this list: send the line "unsubscribe linux-scsi" in the body of a message to [EMAIL PROTECTED] More majordomo info at http://vger.kernel.org/majordomo-info.html
