Natanam,
> I [have] a Pentinum II 350 Mhz machine [with] [an] Initio PCI
> SCSI-Controller [supporting] a 4.4 GB Segate Hard-disk.
> During Installation [it] detected the SCSI controller
> card but the module was not in the [install] table.
> What [should I] do next.
I suspect that absence from the the "install table" means
the module was not found by lsmod(8).
Though not a complete answer, the following may help.
o What is the chipset for the Initio PCI SCSI-Controller?
o Did you select the correct SCSI chipset support in your
configuration (make xconfig) when you built linux?
o Did you select PCI support when you built linux?
o Did you select SCSI hard disk support when you built linux?
o Did you run "make modules" when you built linux?
o Did you run "depmod -a" to update the kernel module table?
o Do you have kerneld installed and running?
o Do you have insmod <each of the above modules> run during
your boot sequence (see /etc/rc.d/*)?
Hopefully helpful,
Bob
P.S. Many non-Windows users prefer that you post in
plain text, since Windows Rich Text is inconvenient
without Windows.
-
To unsubscribe from this list: send the line "unsubscribe linux-scsi" in
the body of a message to [EMAIL PROTECTED]
