Hi,
what kernel are you using (I don't know about slackware 3.6) and are you sure that the
termination is set correct on the bus?
Have you changed the order of the drives (making id1 to id0 and id0 to id1)?
Greetings, Dietmar
>----- Urspr�ngliche Nachricht -----
>Absender: [EMAIL PROTECTED]
>Betreff: SCSI blues
>Empf�nger: [EMAIL PROTECTED]
>Datum: 06. Mai 1999 19:19
>
>
> I have an Adaptec 2940w controler and 2 seagate barracuda
> 9 gig drives. I'm currently trying to install slackware 3.6 and I've
> run
> into two problems. First, the SCSI host recognizes both drives
> on boot up, but linux only sees the one with id 1 (the other has id 0).
>
> I continued and just installed slackware on the drive that was
> recognized. Now that it's installed, I can't seem to be able to
> boot off the hard drive. I did set the boot id in the scsi bios to 1.
> It simply freeezes at the point where it would begin booting of
> the drive.
>
> Sorry if this is a newbie question. Any help would be
> appreciated.
>
> Thanks.
> --
>
> -Holden Robbins
>
> [EMAIL PROTECTED]
> http://www.cparity.com
>
>
>
> -
> To unsubscribe from this list: send the line "unsubscribe linux-scsi" in
> the body of a message to [EMAIL PROTECTED]
>
-
To unsubscribe from this list: send the line "unsubscribe linux-scsi" in
the body of a message to [EMAIL PROTECTED]
