Hi,
I just installed a new 2.2.12 on my computer, at the same time
that I plugged a aha1542 in it with a sony SDT 5200 DAT (4gig).
Bios detection of the card and tape are OK (bios installed, terminators OK,
ID adapter=0, ID tape=2, IO adapter=0x334, IRQ 10, DMA 7, all of which are
free on my system.
SCSI core, HD, TAPE, CDROM, Verbose and AHA1542 were compiled in the kernel.
At boot time, it found the aha1542 adapter with IRQ,DMA, ID and IO OK, but
then
it stayed very long on each nr. from 1 to 7 probing it and saying:
Unable to abort command for target 1 ...
Reseting scsi host0
Unable to abort command for target 1 ...
And then it somehow said it had found the sony tape.
(This lasted at least 3 minutes)
It then started again with nr. 2:
Unable to abort command for target 2 ...
Reseting scsi host0
Unable to abort command for target 2 ...
And then it somehow said it had found the sony tape.
(This lasted at least 3 minutes again)
It then started again with nr. 3:
Unable to abort command for target 3 ...
Reseting scsi host0
Unable to abort command for target 3 ...
And then it somehow said it had found the sony tape.
(This lasted at least 3 minutes again)
And so on for all IDs
At some point it reached the ID 7, where it detected the sony tape again
(whose ID is 2, but it was detected at all IDs) and then (more than 20 minutes
after the start of the booting process) it somehow stopped doing anything.
I'm not quite sure what you need to track the bug down, but I'm ready to do
some
tests.
Bye
Antoine Brenner
---
[EMAIL PROTECTED]
http://www.alinka.com; AlinkA : Cluster Solutions
-
To unsubscribe from this list: send the line "unsubscribe linux-scsi" in
the body of a message to [EMAIL PROTECTED]
