I don't fully understand your question.
but if I would have got the same stuff I'd probably would look through
the scsi bios (Control A at boot if I remember right) settings.
I'd set the HDD to id 0 (to make it bootable) and the tape drive to a
high id so it will have higher priority on the bus (I want the tape to
stream and nothing to interrupt that).
Regards,
/Karl
-----------------------------------------------------------------------
Karl Hammar Asp� Data [EMAIL PROTECTED]
Lilla Asp� 2340 +46 173 140 57
S-742 94 �sthammar Unix for the small company
Sweden +46 70 511 97 84 (mobile)
-----------------------------------------------------------------------
From: Elvis Amaro <[EMAIL PROTECTED]>
Subject: AHA-2940UW Pro
Date: Wed, 22 Mar 2000 14:58:52 +1100
> I'm currently running Redhat Linux 6.0 (Kernel 2.2.5) on an Intel P2. I'm currently
>using an IDE drive & I wish to install a SCSI HDD & Tape Drive.
>
> I have recently purchased an Adaptec AHA-2940UW Pro & connected to it, is a SEAGATE
>harddrive & a WangDAT 3100 DAT drive.
>
> The Kernel has been compiled with the aic-7xxx drivers into it (as a module).
>
> My question is:
>
> What would be the best way to set this SCSI HDD & Tape drive?
>
> OR
>
> Is their any good documentation that someone has come across that I could read to
>help me perform this task?
>
> Many Thanks
> EA
>
>
> -
> To unsubscribe from this list: send the line "unsubscribe linux-scsi" in
> the body of a message to [EMAIL PROTECTED]
-
To unsubscribe from this list: send the line "unsubscribe linux-scsi" in
the body of a message to [EMAIL PROTECTED]
