On Fri, Sep 12, 2014 at 5:15 AM, Maxime Ripard <maxime.rip...@free-electrons.com> wrote: > On Sat, Sep 06, 2014 at 06:47:27PM +0800, Chen-Yu Tsai wrote: >> The DMA controller requires AHB1 bus clock to be clocked from PLL6. >> >> Signed-off-by: Chen-Yu Tsai <w...@csie.org> >> --- >> arch/arm/boot/dts/sun6i-a31.dtsi | 5 +++++ >> 1 file changed, 5 insertions(+) >> >> diff --git a/arch/arm/boot/dts/sun6i-a31.dtsi >> b/arch/arm/boot/dts/sun6i-a31.dtsi >> index 8eb2c6d..1117989 100644 >> --- a/arch/arm/boot/dts/sun6i-a31.dtsi >> +++ b/arch/arm/boot/dts/sun6i-a31.dtsi >> @@ -317,6 +317,11 @@ >> clocks = <&ahb1_gates 6>; >> resets = <&ahb1_rst 6>; >> #dma-cells = <1>; >> + >> + /* DMA controller requires AHB1 clocked from PLL6 */ >> + assigned-clocks = <&ahb1>; >> + assigned-clock-parents = <&pll6>; >> + assigned-clock-rates = <200000000>; > > Where did you get that from? > > The user manual says that it should be clocked at 600MHz, and I'm not > sure it should be enforced there either.
The bindings mean that ahb1 should be clocked from pll6 and at 200 MHz, not "pll6 should be 200 MHz". I assume you were misled by them. Clocking ahb1 from pll6 and at 200 MHz with the /3 pre-divider is the vendor BSP default: On sun6i, the clock init code calls aw_ccu_switch_ahb_2_pll6(), which muxes ahb1 from pll6 with the highest dividers, then sets the rate for ahb1 to pll6, which sets pre-divider to /3 and divider to /1. Hope this clears it up. :) Cheers ChenYu -- You received this message because you are subscribed to the Google Groups "linux-sunxi" group. To unsubscribe from this group and stop receiving emails from it, send an email to linux-sunxi+unsubscr...@googlegroups.com. For more options, visit https://groups.google.com/d/optout.