sunxi_pmx_set accepts pin number and then calculates offset by
subtracting pin_base from it. sunxi_pinctrl_gpio_get, on the other hand,
gets offset so we have to convert it to pin number so we won't get
negative value in sunxi_pmx_set.
This was only used on A10 so far, where there is only one GPIO chip with
pin_base set to 0 so it didn't matter. However H3 also requires this
workaround but have two pinmux sections, triggering problem for PL port.
Signed-off-by: Krzysztof Adamski <k...@japko.eu>
---
drivers/pinctrl/sunxi/pinctrl-sunxi.c | 5 +++--
1 file changed, 3 insertions(+), 2 deletions(-)
diff --git a/drivers/pinctrl/sunxi/pinctrl-sunxi.c
b/drivers/pinctrl/sunxi/pinctrl-sunxi.c
index 7a2465f..96f64a1 100644
--- a/drivers/pinctrl/sunxi/pinctrl-sunxi.c
+++ b/drivers/pinctrl/sunxi/pinctrl-sunxi.c
@@ -459,15 +459,16 @@ static int sunxi_pinctrl_gpio_get(struct gpio_chip *chip,
unsigned offset)
u8 index = sunxi_data_offset(offset);
u32 set_mux = pctl->desc->irq_read_needs_mux &&
test_bit(FLAG_USED_AS_IRQ, &chip->desc[offset].flags);
+ u32 pin = offset + chip->base;
u32 val;
if (set_mux)
- sunxi_pmx_set(pctl->pctl_dev, offset, SUN4I_FUNC_INPUT);
+ sunxi_pmx_set(pctl->pctl_dev, pin, SUN4I_FUNC_INPUT);
val = (readl(pctl->membase + reg) >> index) & DATA_PINS_MASK;
if (set_mux)
- sunxi_pmx_set(pctl->pctl_dev, offset, SUN4I_FUNC_IRQ);
+ sunxi_pmx_set(pctl->pctl_dev, pin, SUN4I_FUNC_IRQ);
return !!val;
}
--
2.1.4
--
You received this message because you are subscribed to the Google Groups
"linux-sunxi" group.
To unsubscribe from this group and stop receiving emails from it, send an email
to linux-sunxi+unsubscr...@googlegroups.com.
For more options, visit https://groups.google.com/d/optout.
