From: Jelle van der Waa <[email protected]> Enable the WiFi (AP6212) chip and eMMC support for the NanoPi NEO Air.
This patch was originally submitted by Jelle van der Waa. Martin Kelly modified it to compile on the latest kernel, fixed up some review comments from Maxime Ripard, and re-tested the patch. These are the original patch submissions: https://patchwork.kernel.org/patch/9581613/ https://patchwork.kernel.org/patch/9642071/ Cc: Maxime Ripard <[email protected]> Cc: [email protected] Cc: [email protected] Signed-off-by: Jelle van der Waa <[email protected]> Signed-off-by: Martin Kelly <[email protected]> --- arch/arm/boot/dts/sun8i-h3-nanopi-neo-air.dts | 24 ++++++++++++++++++++++++ 1 file changed, 24 insertions(+) diff --git a/arch/arm/boot/dts/sun8i-h3-nanopi-neo-air.dts b/arch/arm/boot/dts/sun8i-h3-nanopi-neo-air.dts index 03ff6f8b93ff..920849092cc8 100644 --- a/arch/arm/boot/dts/sun8i-h3-nanopi-neo-air.dts +++ b/arch/arm/boot/dts/sun8i-h3-nanopi-neo-air.dts @@ -72,6 +72,11 @@ gpios = <&pio 0 10 GPIO_ACTIVE_HIGH>; /* PA10 */ }; }; + + wifi_pwrseq: wifi_pwrseq { + compatible = "mmc-pwrseq-simple"; + reset-gpios = <&r_pio 0 7 GPIO_ACTIVE_LOW>; /* PL7 */ + }; }; &mmc0 { @@ -84,6 +89,25 @@ status = "okay"; }; +&mmc1 { + pinctrl-names = "default"; + pinctrl-0 = <&mmc1_pins_a>; + vmmc-supply = <®_vcc3v3>; + vqmmc-supply = <®_vcc3v3>; + mmc-pwrseq = <&wifi_pwrseq>; + bus-width = <4>; + non-removable; + status = "okay"; + + brcmf: bcrmf@1 { + reg = <1>; + compatible = "brcm,bcm4329-fmac"; + interrupt-parent = <&pio>; + interrupts = <6 10 IRQ_TYPE_LEVEL_LOW>; /* PG10 / EINT10 */ + interrupt-names = "host-wake"; + }; +}; + &uart0 { pinctrl-names = "default"; pinctrl-0 = <&uart0_pins_a>; -- 2.11.0 -- You received this message because you are subscribed to the Google Groups "linux-sunxi" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. For more options, visit https://groups.google.com/d/optout.
