The RX/TX delays for the Ethernet PHY on the Linksprite pcDuino 3 Nano are configured in hardware, using resistors that are populated to pull the RTL8211E's RXDLY/TXDLY pins low or high as needed.
phy-mode should be set to rgmii-id to reflect this. Previously it was set to rgmii, which used to work but now results in the delays being disabled again as a result of the bugfix in commit bbc4d71d6354 ("net: phy: realtek: fix rtl8211e rx/tx delay config"). Tested on two pcDuino 3 Nano boards purchased in 2015. Without this fix, Ethernet works unreliably on one board and doesn't work at all on the other. Fixes: 061035d456c9 ("ARM: dts: sun7i: Add dts file for pcDuino 3 Nano board") Signed-off-by: Adam Sampson <a...@offog.org> Reviewed-by: Andrew Lunn <and...@lunn.ch> Acked-by: Chen-Yu Tsai <w...@csie.org> --- arch/arm/boot/dts/sun7i-a20-pcduino3-nano.dts | 4 ++-- 1 file changed, 2 insertions(+), 2 deletions(-) diff --git a/arch/arm/boot/dts/sun7i-a20-pcduino3-nano.dts b/arch/arm/boot/dts/sun7i-a20-pcduino3-nano.dts index fce2f7fcd084..bf38c66c1815 100644 --- a/arch/arm/boot/dts/sun7i-a20-pcduino3-nano.dts +++ b/arch/arm/boot/dts/sun7i-a20-pcduino3-nano.dts @@ -1,5 +1,5 @@ /* - * Copyright 2015 Adam Sampson <a...@offog.org> + * Copyright 2015-2020 Adam Sampson <a...@offog.org> * * This file is dual-licensed: you can use it either under the terms * of the GPL or the X11 license, at your option. Note that this dual @@ -115,7 +115,7 @@ &gmac { pinctrl-names = "default"; pinctrl-0 = <&gmac_rgmii_pins>; phy-handle = <&phy1>; - phy-mode = "rgmii"; + phy-mode = "rgmii-id"; status = "okay"; }; -- 2.29.1 -- You received this message because you are subscribed to the Google Groups "linux-sunxi" group. To unsubscribe from this group and stop receiving emails from it, send an email to linux-sunxi+unsubscr...@googlegroups.com. To view this discussion on the web, visit https://groups.google.com/d/msgid/linux-sunxi/20201123174739.6809-1-ats%40offog.org.