Johannes Erdfelt wrote:
> 
> On Tue, May 28, 2002, Stephan Feder <[EMAIL PROTECTED]> wrote:
> > Greg KH wrote:
> > >
> > > Ok, now that 2.5.16 is out, we have a total of 4 different USB UHCI
> > > controller drivers in the kernel!  That's about 3 too many for me :)
> > ...
> >
> > 1. I tried uhci-hcd and usb-uhci-hcd with linux-2.5.18 and in both cases
> > I get "usb_control/bulk_msg: timeout" while reading from my scanner
> > (using the scanner module). Same with every kernel I tested from 2.4.0
> > up to 2.4.18 with uhci and usb-uhci. Reported on this list last august.
> >
> > 2. usb-uhci-hcd is up to 10% faster than uhci-hcd. This is critical for
> > me because I cannot have the scan process stop every other scanline
> > (hardware is cheap but not that cheap).
> 
> What hardware is this again?
...

I attached the output of lspci and lsusb. If you need more information
just ask.

Regards
        Stephan
00:00.0 Host bridge: Intel Corporation 430HX - 82439HX TXC [Triton II] (rev 03)
        Control: I/O- Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- 
SERR+ FastB2B-
        Status: Cap- 66Mhz- UDF- FastB2B- ParErr- DEVSEL=medium >TAbort- <TAbort- 
<MAbort+ >SERR- <PERR-
        Latency: 32

00:07.0 ISA bridge: Intel Corporation 82371SB PIIX3 ISA [Natoma/Triton II] (rev 01)
        Control: I/O+ Mem+ BusMaster+ SpecCycle+ MemWINV- VGASnoop- ParErr- Stepping- 
SERR- FastB2B-
        Status: Cap- 66Mhz- UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort- <TAbort- 
<MAbort- >SERR- <PERR-
        Latency: 0

00:07.1 IDE interface: Intel Corporation 82371SB PIIX3 IDE [Natoma/Triton II] (prog-if 
80 [Master])
        Control: I/O+ Mem- BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- 
SERR- FastB2B-
        Status: Cap- 66Mhz- UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort- <TAbort- 
<MAbort- >SERR- <PERR-
        Latency: 64
        Region 4: I/O ports at e800 [size=16]

00:07.2 USB Controller: Intel Corporation 82371SB PIIX3 USB [Natoma/Triton II] (rev 
01) (prog-if 00 [UHCI])
        Control: I/O+ Mem- BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- 
SERR- FastB2B-
        Status: Cap- 66Mhz- UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort- <TAbort- 
<MAbort- >SERR- <PERR-
        Latency: 64
        Interrupt: pin D routed to IRQ 9
        Region 4: I/O ports at e400 [size=32]

00:09.0 Network controller: AVM Audiovisuelles MKTG & Computer System GmbH A1 ISDN 
[Fritz] (rev 02)
        Subsystem: AVM Audiovisuelles MKTG & Computer System GmbH FRITZ!Card ISDN 
Controller
        Control: I/O+ Mem+ BusMaster- SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- 
SERR- FastB2B-
        Status: Cap- 66Mhz- UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort- <TAbort- 
<MAbort- >SERR- <PERR-
        Interrupt: pin A routed to IRQ 9
        Region 0: Memory at e7000000 (32-bit, non-prefetchable) [size=32]
        Region 1: I/O ports at e000 [size=32]

00:0a.0 SCSI storage controller: Symbios Logic Inc. (formerly NCR) 53c810 (rev 12)
        Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV+ VGASnoop- ParErr- Stepping- 
SERR- FastB2B-
        Status: Cap- 66Mhz- UDF- FastB2B- ParErr- DEVSEL=medium >TAbort- <TAbort- 
<MAbort- >SERR- <PERR-
        Latency: 64 (2000ns min, 16000ns max), cache line size 08
        Interrupt: pin A routed to IRQ 10
        Region 0: I/O ports at d800 [size=256]
        Region 1: Memory at e6800000 (32-bit, non-prefetchable) [size=256]

00:0b.0 Ethernet controller: Realtek Semiconductor Co., Ltd. RTL-8139 (rev 10)
        Subsystem: Accton Technology Corporation: Unknown device ec01
        Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- 
SERR- FastB2B-
        Status: Cap+ 66Mhz- UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort- <TAbort- 
<MAbort- >SERR- <PERR-
        Latency: 64 (8000ns min, 16000ns max)
        Interrupt: pin A routed to IRQ 11
        Region 0: I/O ports at d400 [size=256]
        Region 1: Memory at e6000000 (32-bit, non-prefetchable) [size=256]
        Expansion ROM at <unassigned> [disabled] [size=64K]
        Capabilities: <available only to root>

00:0c.0 VGA compatible controller: Alliance Semiconductor Corporation ProMotion AT3D 
(rev 02) (prog-if 00 [VGA])
        Control: I/O+ Mem+ BusMaster- SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- 
SERR- FastB2B-
        Status: Cap- 66Mhz+ UDF- FastB2B- ParErr- DEVSEL=slow >TAbort- <TAbort- 
<MAbort- >SERR- <PERR-
        Region 0: Memory at e5000000 (32-bit, non-prefetchable) [size=16M]
        Region 1: I/O ports at d000 [size=16]
        Expansion ROM at <unassigned> [disabled] [size=64K]

Bus 001 Device 001: ID 0000:0000 Virtual Hub
Device Descriptor:
  bLength                18
  bDescriptorType         1
  bcdUSB               1.00
  bDeviceClass            9 Hub
  bDeviceSubClass         0 
  bDeviceProtocol         0 
  bMaxPacketSize0         8
  idVendor           0x0000 Virtual
  idProduct          0x0000 Hub
  bcdDevice            0.00
  iManufacturer           0 
  iProduct                2 
  iSerial                 1 
  bNumConfigurations      1
  Configuration Descriptor:
    bLength                 9
    bDescriptorType         2
    wTotalLength           25
    bNumInterfaces          1
    bConfigurationValue     1
    iConfiguration          0
    bmAttributes         0x40
      Self Powered
    MaxPower                0mA
    Interface Descriptor:
      bLength                 9
      bDescriptorType         4
      bInterfaceNumber        0
      bAlternateSetting       0
      bNumEndpoints           1
      bInterfaceClass         9 Hub
      bInterfaceSubClass      0 
      bInterfaceProtocol      0 
      iInterface              0 
      Endpoint Descriptor:
        bLength                 7
        bDescriptorType         5
        bEndpointAddress     0x81  EP 1 IN
        bmAttributes            3
          Transfer Type            Interrupt
          Synch Type               none
        wMaxPacketSize          8
        bInterval             255
  Language IDs: 0000
Bus 001 Device 002: ID 04b8:010b Seiko Epson Corp. 
Device Descriptor:
  bLength                18
  bDescriptorType         1
  bcdUSB               1.00
  bDeviceClass          255 Vendor Specific Class
  bDeviceSubClass       255 Vendor Specific Subclass
  bDeviceProtocol       255 Vendor Specific Protocol
  bMaxPacketSize0        64
  idVendor           0x04b8 Seiko Epson Corp.
  idProduct          0x010b 
  bcdDevice            1.14
  iManufacturer           1 EPSON
  iProduct                2 Perfection1240
  iSerial                 0 
  bNumConfigurations      1
  Configuration Descriptor:
    bLength                 9
    bDescriptorType         2
    wTotalLength           32
    bNumInterfaces          1
    bConfigurationValue     1
    iConfiguration          0
    bmAttributes         0x40
      Self Powered
    MaxPower                2mA
    Interface Descriptor:
      bLength                 9
      bDescriptorType         4
      bInterfaceNumber        0
      bAlternateSetting       0
      bNumEndpoints           2
      bInterfaceClass       255 Vendor Specific Class
      bInterfaceSubClass    255 Vendor Specific Subclass
      bInterfaceProtocol    255 Vendor Specific Protocol
      iInterface              0 
      Endpoint Descriptor:
        bLength                 7
        bDescriptorType         5
        bEndpointAddress     0x81  EP 1 IN
        bmAttributes            2
          Transfer Type            Bulk
          Synch Type               none
        wMaxPacketSize         64
        bInterval               0
      Endpoint Descriptor:
        bLength                 7
        bDescriptorType         5
        bEndpointAddress     0x02  EP 2 OUT
        bmAttributes            2
          Transfer Type            Bulk
          Synch Type               none
        wMaxPacketSize         64
        bInterval               0
  Language IDs: 0409

Reply via email to