Hi,
Andrew Morton wrote:
Running 2.6.7-rc2-mm2, I connected up the Sony digital camera.
dmesg says:
From two days ago:
usb 4-2: new full speed USB device using address 2 Initializing USB Mass Storage driver... scsi2 : SCSI emulation for USB Mass Storage devices Vendor: Sony Model: Sony DSC Rev: 3.28 Type: Direct-Access ANSI SCSI revision: 02 SCSI device sdc: 31680 512-byte hdwr sectors (16 MB) sdc: assuming Write Enabled sdc: assuming drive cache: write through sdc: sdc1 Attached scsi removable disk sdc at scsi2, channel 0, id 0, lun 0 USB Mass Storage device found at 2 usbcore: registered new driver usb-storage USB Mass Storage support registered. inserting floppy driver for 2.6.7-rc2-mm2 Floppy drive(s): fd0 is 1.44M FDC 0 is a post-1991 82077 usb 4-2: USB disconnect, address 2
But today it hung:
usb 4-2: new full speed USB device using address 3 scsi3 : SCSI emulation for USB Mass Storage devices
Similar problem here - probably the same thing. usb-storage works fine the first time you plug the device in. If you then unplug and replug, you'll get those hangs until the next time you reboot.
I'll spend a bit more time on it later
Daniel
------------------------------------------------------- This SF.Net email is sponsored by the new InstallShield X.
From Windows to Linux, servers to mobile, InstallShield X is the one
installation-authoring solution that does it all. Learn more and evaluate today! http://www.installshield.com/Dev2Dev/0504 _______________________________________________ [EMAIL PROTECTED] To unsubscribe, use the last form field at: https://lists.sourceforge.net/lists/listinfo/linux-usb-devel
