I pulled Linus 2.6.7-bk17 into Gregs usb-2.6 tree. It works ok on 2 different ibook G3, but hangs on an ibook G4. Havent tried other machines yet.
Any idea what patch can cause this? ... ohci_hcd 0001:01:1b.1: new USB bus registered, assigned bus number 3 hub 3-0:1.0: USB hub found hub 3-0:1.0: 2 ports detected <hangs> cursor does still blink. Total memory = 640MB; using 2048kB for hash table (at c0600000) Linux version 2.6.7-bk17 ([EMAIL PROTECTED]) (gcc version 3.3.3 (SuSE Linux)) #12 Mon Jul 5 13:49:04 CEST 2004 Found UniNorth memory controller & host bridge, revision: 210 Mapped at 0xfdf00000 Found a Intrepid mac-io controller, rev: 0, mapped at 0xfde80000 Processor NAP mode on idle enabled. PowerMac motherboard: iBook G4 Found UniNorth PCI host bridge at 0xf0000000. Firmware bus number: 0->0 Found UniNorth PCI host bridge at 0xf2000000. Firmware bus number: 0->0 Found UniNorth PCI host bridge at 0xf4000000. Firmware bus number: 0->0 via-pmu: Server Mode is disabled PMU driver 2 initialized for Core99, firmware: 0c nvram: Checking bank 0... nvram: gen0=522, gen1=521 nvram: Active bank is: 0 nvram: OF partition at 0x410 nvram: XP partition at 0x1020 nvram: NR partition at 0x1120 On node 0 totalpages: 163840 DMA zone: 163840 pages, LIFO batch:16 Normal zone: 0 pages, LIFO batch:1 HighMem zone: 0 pages, LIFO batch:1 Built 1 zonelists Kernel command line: root=/dev/hda6 selinux=0 elevator=cfq 3 PowerMac using OpenPIC irq controller at 0x80040000 OpenPIC Version 1.2 (4 CPUs and 64 IRQ sources) at fc62f000 OpenPIC timer frequency is 4.166666 MHz PID hash table entries: 4096 (order 12: 32768 bytes) GMT Delta read from XPRAM: 0 minutes, DST: off time_init: decrementer frequency = 18.432000 MHz Console: colour dummy device 80x25 Dentry cache hash table entries: 131072 (order: 7, 524288 bytes) Inode-cache hash table entries: 65536 (order: 6, 262144 bytes) Memory: 640704k available (2784k kernel code, 1844k data, 180k init, 0k highmem) AGP special page: 0xe7fff000 Calibrating delay loop... 761.85 BogoMIPS Security Scaffold v1.0.0 initialized SELinux: Disabled at boot. Capability LSM initialized Mount-cache hash table entries: 512 (order: 0, 4096 bytes) checking if image is initramfs... it is Freeing initrd memory: 1192k freed NET: Registered protocol family 16 PCI: Probing PCI hardware PCI: Cannot allocate resource region 0 of device 0001:01:18.0 PCI: Cannot allocate resource region 0 of device 0001:01:19.0 Registering openpic with sysfs... usbcore: registered new driver usbfs usbcore: registered new driver hub TC classifier action (bugs to [EMAIL PROTECTED] cc [EMAIL PROTECTED]) PCI: Enabling device 0000:00:10.0 (0006 -> 0007) radeonfb: Invalid ROM signature 0 should be 0xaa55 radeonfb: Retreived PLL infos from Open Firmware radeonfb: Reference=27.00 MHz (RefDiv=12) Memory=190.00 Mhz, System=183.00 MHz radeonfb: Monitor 1 type LCD found radeonfb: EDID probed radeonfb: Monitor 2 type no found radeonfb: Power Management enabled for Mobility chipsets Registered "mnca" backlight controller, level: 15/15 radeonfb: ATI Radeon \c DDR SGRAM 32 MB Thermal assist unit not available audit: initializing netlink socket (disabled) audit(1089035443.498:0): initialized VFS: Disk quotas dquot_6.5.1 Dquot-cache hash table entries: 1024 (order 0, 4096 bytes) Initializing Cryptographic API Console: switching to colour frame buffer device 128x48 Generic RTC Driver v1.07 Macintosh non-volatile memory driver v1.1 pmac_zilog: 0.6 (Benjamin Herrenschmidt <[EMAIL PROTECTED]>) ttyS0 at MMIO 0x80013020 (irq = 22) is a Z85c30 ESCC - Serial port ttyS1 at MMIO 0x80013000 (irq = 23) is a Z85c30 ESCC - Serial port RAMDISK driver initialized: 16 RAM disks of 123456K size 1024 blocksize loop: loaded (max 8 devices) MacIO PCI driver attached to Intrepid chipset Can't request resource 0 for MacIO device 0.80000000:mac-io input: Macintosh mouse button emulation apm_emu: APM Emulation 0.5 initialized. Uniform Multi-Platform E-IDE driver Revision: 7.00alpha2 ide: Assuming 33MHz system bus speed for PIO modes; override with idebus=xx PCI: Enabling device 0002:02:0d.0 (0000 -> 0002) adb: starting probe task... adb devices: [2]: 2 c4 [3]: 3 1 [7]: 7 1f ADB keyboard at 2, handler 1 Detected ADB keyboard, type ISO, swapping keys. input: ADB keyboard on adb2:2.c4/input input: ADB Powerbook buttons on adb7:7.1f/input ADB mouse at 3, handler set to 4 (trackpad) input: ADB mouse on adb3:3.01/input adb: finished probe task... ide0: Found Apple UniNorth ATA-6 controller, bus ID 3, irq 39 Probing IDE interface ide0... hda: FUJITSU MHT2060AT, ATA DISK drive hda: Enabling Ultra DMA 5 Using cfq io scheduler ide0 at 0xea104000-0xea104007,0xea104160 on irq 39 ide1: Found Apple KeyLargo ATA-3 controller, bus ID 0, irq 24 Probing IDE interface ide1... hdc: MATSHITACD-RW CW-8123, ATAPI CD/DVD-ROM drive hdc: MDMA, cycleTime: 120, accessTime: 90, recTime: 30 hdc: Set MDMA timing for mode 2, reg: 0x00011d26 hdc: Enabling MultiWord DMA 2 ide1 at 0xea107000-0xea107007,0xea107160 on irq 24 hda: max request size: 1024KiB hda: 117210240 sectors (60011 MB) w/8192KiB Cache, CHS=16383/255/63, UDMA(100) hda: [mac] hda1 hda2 hda3 hda4 hda5 hda6 hda7 hda8 hda9 hdc: ATAPI 24X DVD-ROM CD-R/RW drive, 2048kB Cache, (U)DMA Uniform CD-ROM driver Revision: 3.20 ohci_hcd: 2004 Feb 02 USB 1.1 'Open' Host Controller (OHCI) Driver (PCI) ohci_hcd: block sizes: ed 64 td 64 PCI: Enabling device 0001:01:18.0 (0000 -> 0002) ohci_hcd 0001:01:18.0: Found HC with no IRQ. Check BIOS/PCI 0001:01:18.0 setup! PCI: Enabling device 0001:01:19.0 (0000 -> 0002) ohci_hcd 0001:01:19.0: Found HC with no IRQ. Check BIOS/PCI 0001:01:19.0 setup! PCI: Enabling device 0001:01:1a.0 (0000 -> 0002) ohci_hcd 0001:01:1a.0: OHCI Host Controller ohci_hcd 0001:01:1a.0: irq 29, pci mem ea10c000 ohci_hcd 0001:01:1a.0: new USB bus registered, assigned bus number 1 hub 1-0:1.0: USB hub found hub 1-0:1.0: 2 ports detected PCI: Enabling device 0001:01:1b.0 (0000 -> 0002) ohci_hcd 0001:01:1b.0: OHCI Host Controller ohci_hcd 0001:01:1b.0: irq 63, pci mem ea10e000 ohci_hcd 0001:01:1b.0: new USB bus registered, assigned bus number 2 hub 2-0:1.0: USB hub found hub 2-0:1.0: 3 ports detected PCI: Enabling device 0001:01:1b.1 (0000 -> 0002) ohci_hcd 0001:01:1b.1: OHCI Host Controller ohci_hcd 0001:01:1b.1: irq 63, pci mem ea110000 ohci_hcd 0001:01:1b.1: new USB bus registered, assigned bus number 3 hub 3-0:1.0: USB hub found hub 3-0:1.0: 2 ports detected usbcore: registered new driver hiddev usbcore: registered new driver usbhid drivers/usb/input/hid-core.c: v2.0:USB HID core driver mice: PS/2 mouse device common for all mice md: md driver 0.90.0 MAX_MD_DEVS=256, MD_SB_DISKS=27 NET: Registered protocol family 2 IP: routing cache hash table of 8192 buckets, 64Kbytes TCP: Hash tables configured (established 262144 bind 65536) NET: Registered protocol family 1 NET: Registered protocol family 17 Freeing unused kernel memory: 180k init 4k chrp 32k prep ReiserFS: hda6: found reiserfs format "3.6" with standard journal ReiserFS: hda6: using ordered data mode ReiserFS: hda6: journal params: device hda6, size 8192, journal first block 18, max trans len 1024, max batch 900, max commit age 30, max trans age 30 ReiserFS: hda6: checking transaction log (hda6) ReiserFS: hda6: Using r5 hash to sort names Adding 1048568k swap on /dev/hda5. Priority:42 extents:1 md: Autodetecting RAID arrays. md: autorun ... md: ... autorun DONE. device-mapper: 4.1.0-ioctl (2003-12-10) initialised: [EMAIL PROTECTED] kjournald starting. Commit interval 5 seconds EXT3 FS on hda7, internal journal EXT3-fs: mounted filesystem with ordered data mode. sungem.c:v0.98 8/24/03 David S. Miller ([EMAIL PROTECTED]) eth0: Sun GEM (PCI) 10/100/1000BaseT Ethernet 00:0a:95:aa:0c:fa PHY ID: 4061e4, addr: 0 eth0: Found BCM5221 PHY eth0: Link is up at 100 Mbps, full-duplex. eth0: Pause is disabled Linux agpgart interface v0.100 (c) Dave Jones agpgart: Detected Apple UniNorth 2 chipset agpgart: Maximum main memory to use for agp memory: 565M agpgart: configuring for size idx: 4 agpgart: AGP aperture is 16M @ 0x0 PCI: Enabling device 0001:01:1b.2 (0004 -> 0006) ehci_hcd 0001:01:1b.2: EHCI Host Controller ehci_hcd 0001:01:1b.2: irq 63, pci mem ea252000 ehci_hcd 0001:01:1b.2: new USB bus registered, assigned bus number 4 ehci_hcd 0001:01:1b.2: USB 2.0 enabled, EHCI 1.00, driver 2004-May-10 hub 4-0:1.0: USB hub found hub 4-0:1.0: 5 ports detected ieee1394: Initialized config rom entry `ip1394' ohci1394: $Rev: 1223 $ Ben Collins <[EMAIL PROTECTED]> PCI: Enabling device 0002:02:0e.0 (0000 -> 0002) ohci1394: fw-host0: Unexpected PCI resource length of 1000! ohci1394: fw-host0: OHCI-1394 1.1 (PCI): IRQ=[40] MMIO=[f5000000-f50007ff] Max Packet=[2048] ieee1394: Host added: ID:BUS[0-00:1023] GUID[000a95fffeaa0cfa] NET: Registered protocol family 10 Disabled Privacy Extensions on device c0332964(lo) IPv6 over IPv4 tunneling driver Disabled Privacy Extensions on device e5c83000(sit0) SCSI subsystem initialized st: Version 20040403, fixed bufsize 32768, s/g segs 256 -- USB is for mice, FireWire is for men! sUse lINUX ag, nÃRNBERG ------------------------------------------------------- This SF.Net email sponsored by Black Hat Briefings & Training. Attend Black Hat Briefings & Training, Las Vegas July 24-29 - digital self defense, top technical experts, no vendor pitches, unmatched networking opportunities. Visit www.blackhat.com _______________________________________________ [EMAIL PROTECTED] To unsubscribe, use the last form field at: https://lists.sourceforge.net/lists/listinfo/linux-usb-devel
