-----BEGIN PGP SIGNED MESSAGE----- Hash: SHA1
David Brownell wrote: | It's something wierd that started a while back, and so far | it doesn't make sense to me. But see below, and please | try the patch I've attached. If it fails, please send | the full CONFIG_USB_DEBUG output showing the error (as | below) and contents of /sys/class/usb_host/usb4/registers | after the fault.
I've tried the patch and it failed.
http://www.dune.net/linux/laptop/dmesg-usbdebug-ehcipatch.gz
the debug output is here:
archon usb4 # cat registers bus pci, device 0000:00:1d.7 (driver 26 Oct 2004) EHCI 1.00, hcd state 0 structural params 0x00103206 capability params 0x00006871 status 1004 Halt PCD command 080000 (park)=0 ithresh=8 period=1024 HALT intrenable 00 uframe 0000 port 1 status 003030 POWER OWNER sig=se0 OCC OC port 2 status 003030 POWER OWNER sig=se0 OCC OC port 3 status 003000 POWER OWNER sig=se0 port 4 status 003000 POWER OWNER sig=se0 port 5 status 003000 POWER OWNER sig=se0 port 6 status 003000 POWER OWNER sig=se0 irq normal 0 err 0 reclaim 0 (lost 0) complete 0 unlink 0 archon usb4 #
|>hub 4-0:1.0: individual port over-current protection |>hub 4-0:1.0: Single TT |>hub 4-0:1.0: TT requires at most 8 FS bit times |>hub 4-0:1.0: power on to power good time: 20ms |>hub 4-0:1.0: local power source is good |>hub 4-0:1.0: enabling power on all ports |>hub 4-0:1.0: state 5 ports 6 chg ffff evt ffff |>ehci_hcd 0000:00:1d.7: GetStatus port 1 status 001030 POWER sig=se0 OCC OC |>hub 4-0:1.0: over-current change on port 1 | | | Seems like a lot of people who get this error get it along with | an "overcurrent" error on port 1, right after the chip has been | initialized.
These overcurrent warnings/errors also happen sometimes on windows when changing between battery and AC power or removing battery. Not very reproducible.
| I suspect the problem comes as a side effect of something | else. It could be board-related, but it doesn't seem | to be chip-related. I've seen reports of this with | ALI, NEC, and Intel chips, but it doesn't happen for | me with ALI or NEC chips; and plenty of folk are using | those chips without seeing this problem.
unlucky me :-(
I'll try to help on anything that's needed, on my free time, of course.
thanks for the help.
regards, pedro venda. - --
Pedro Jo�o Lopes Venda email: [EMAIL PROTECTED] http://arrakis.dhis.org -----BEGIN PGP SIGNATURE----- Version: GnuPG v1.2.6 (GNU/Linux) Comment: Using GnuPG with Thunderbird - http://enigmail.mozdev.org
iD8DBQFB2evSeRy7HWZxjWERAkmSAJ9Hf3Rn2zZPN5MkIaEI4q71MlZLwwCfW5Ua OnNGvi7vgEn8cR7pVFRqCcc= =592G -----END PGP SIGNATURE-----
------------------------------------------------------- The SF.Net email is sponsored by: Beat the post-holiday blues Get a FREE limited edition SourceForge.net t-shirt from ThinkGeek. It's fun and FREE -- well, almost....http://www.thinkgeek.com/sfshirt _______________________________________________ [email protected] To unsubscribe, use the last form field at: https://lists.sourceforge.net/lists/listinfo/linux-usb-devel
