Well, I didn't think I had any other USB devices to try out, but then I remembered a USB CueCat packed away... so I unwrapped it and plugged it in; I figured at least the LED will light up and the logs might say something positive. No such luck... light stayed out, and the dmesg reports: hub.c: port 1 connection change hub.c: port 1, portstatus 101, change 1, 12 Mb/s hub.c: port 1, portstatus 101, change 0, 12 Mb/s hub.c: port 1 of hub 1 not reset yet, waiting 10ms The last 2 lines above repeated probably 10-12 times, but waiting 200ms instead of 10ms after the second time. Then: hub.c: port 1 of hub 1 not enabled, trying reset again... hub.c: Cannot enable port 1 of hub 1, disabling port. hub.c: Maybe the USB cable is bad? So... obviously this is a problem either with my hardware or with the UHCI driver just not liking my hardware (I tried both UHCI drivers). This only happens with one port-- the other apparently does nothing. But, when I load the module, it does detect 2 ports, UHCI at 0x6300 and IRQ 11, and it detects the main device as a Root Hub. However, when I load the alternate UHCI driver I get, as I mentioned before, a message that says: uhci: host controller halted, very bad So from here I don't know where to go. Any suggestions? Thanks, --Mike --- Michael S. Moulton UZ 541+UUD Lord Bodak [EMAIL PROTECTED] VT Class of 2001 _______________________________________________ [EMAIL PROTECTED] To unsubscribe, use the last form field at: http://lists.sourceforge.net/lists/listinfo/linux-usb-users
