Stephen,
I'm returning to You with help request.
I return STlab converter to shop and bought *Billionton* ThumbLAN USBKR-100B (RTL1850 based).
Now device is recognized by system. Here are entries from syslog
Oct 22 11:19:55 mythtv lircd-0.7.2pvr150[3960]: accepted new client on /dev/lircd
Oct 22 11:21:04 mythtv kernel: usb 2-1: new full speed USB device using uhci_hcd and address 2
Oct 22 11:21:06 mythtv kernel: drivers/usb/net/rtl8150.c: rtl8150 based usb-ethernet driver v0.6.2 (2004/08/27)
Oct 22 11:21:06 mythtv kernel: drivers/usb/net/rtl8150.c: eth%%d: rtl8150 is detected
Oct 22 11:21:06 mythtv kernel: usbcore: registered new driver rtl8150
Oct 22 11:21:06 mythtv usb.agent[6151]: rtl8150: loaded successfully
Here are entries from /proc/bus/usb/devices
T: Bus=02 Lev=01 Prnt=01 Port=00 Cnt=01 Dev#= 3 Spd=12 MxCh= 0
D: Ver= 1.10 Cls=00(>ifc ) Sub=00 Prot=00 MxPS= 8 #Cfgs= 1
P: Vendor=0bda ProdID=8150 Rev= 1.00
S: Manufacturer=USBKR100
S: Product=USB 10/100 LAN
S: SerialNumber=3903
C:* #Ifs= 1 Cfg#= 1 Atr=a0 MxPwr=120mA
I: If#= 0 Alt= 0 #EPs= 3 Cls=ff(vend.) Sub=00 Prot=ff Driver=rtl8150
E: Ad=81(I) Atr=02(Bulk) MxPS= 64 Ivl=0ms
E: Ad=02(O) Atr=02(Bulk) MxPS= 64 Ivl=0ms
E: Ad=83(I) Atr=03(Int.) MxPS= 8 Ivl=1ms
But when I type ifconfig, only lo and eth0 are present. No USB0.
How can configure system to create & use this adapter as second Eth intf ?
million than in advance !
-------------------------------------------------------
This SF.Net email is sponsored by:
Power Architecture Resource Center: Free content, downloads, discussions,
and more. http://solutions.newsforge.com/ibmarch.tmpl
_______________________________________________
[email protected]
To unsubscribe, use the last form field at:
https://lists.sourceforge.net/lists/listinfo/linux-usb-users
