Thanks. The problem is that any message i send afterward returns the same error.
Including set configuration/etc. On the uchi.c driver, however after a 10 second
timeout, everything then works! Is there any way to clear the state of the usb-uhci
driver so that i can re-attempt to connect to the device?
Mike
On Sat, Apr 08, 2000 at 03:57:12PM +0200, Georg Acher wrote:
> On Sat, Apr 08, 2000 at 01:21:58AM +0000, Michael W Zappe wrote:
> > I'm having trouble clearing halts on an endpoint with the kawasaki
> > ethernet driver. I submit a control URB, which times out, and then
> > every URB i submit to the control pipes ends up returning with an
> > error message like this with the usb-uhci driver.
> >
> > usb_control/bulk_msg: timeout
> > usb-uhci.c: interrupt, status 3, frame# 1209
> > usb-uhci-debug.h: TD @ c7ddc9e0/07DDC9E0, MaxLen=07 DT0 EP=0 Dev=4 PID=(SETUP0
> > usb-uhci-debug.h: Len=07 e0 SPD Stalled CRC/Timeo
> > usb-uhci-debug.h: Link points to TD @ 07ddc920, Breadth first
>
> This is an USB protocol violation error. We should use bold letters for
> "Timeout" in the kernel log. The device simply doesn't respond anymore,
> there's even no error returned.
>
> I have no idea why this happens...
> --
> Bye
> Georg Acher, [EMAIL PROTECTED]
> http://www.in.tum.de/~acher/
> "Oh no, not again !" The bowl of petunias
>
> ---------------------------------------------------------------------
> To unsubscribe, e-mail: [EMAIL PROTECTED]
> For additional commands, e-mail: [EMAIL PROTECTED]
---------------------------------------------------------------------
To unsubscribe, e-mail: [EMAIL PROTECTED]
For additional commands, e-mail: [EMAIL PROTECTED]
