I just bought a Linksys USB100TX. I'm running a 2.2.14 kernel with the
USB backport patches (usb-2.3.99-pre7-1-for-2.2.14.diff.gz).
If I load the pegasus driver after the usb-ohci driver, then it doesn't
detect the card unless I unplug then replug it.
If I load the pegasus driver before the usb-ohci driver, then it sees
the device without replugging it.
It identifies it as manufactured by Lynksys, shows the last three bytes
of the mac address as the serial number, assigns "eth1: Linksys
USB100TX". If I ifconfig it:
# /sbin/ifconfig eth1
eth1 Link encap:Ethernet HWaddr 00:00:00:00:00:00
BROADCAST MULTICAST MTU:1500 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:100
If I try to configure it:
# /sbin/ifconfig eth1 192.168.0.1 up
SIOCSIFFLAGS: Input/output error
SIOCSIFFLAGS: Input/output error
And the console spews the error:
pegasus_rw_srom_word() failed
Can't start_net() -1
Twice.
Any ideas?
Thanks,
Chris
---------------------------------------------------------------------
To unsubscribe, e-mail: [EMAIL PROTECTED]
For additional commands, e-mail: [EMAIL PROTECTED]
