II've take the 2.3.99 kernel and compile it with the USB support. I've a
hub with my monitor (LG Flatron 795FT) with a printer (Epson 740) and a
WebCam (Creative WebCam Go!) attached.
Unfortunatly i'm not able to get them work. I've read the USB Guide and the
USB how-to, but nothing. I've tried to make usblp0 and then to configure it
with the Mandrake printer tool, but when I try to print nothing appen.
This is the part of dmesg about USB (I hope is complete...) :
usb.c: registered new driver usbdevfs
usb.c: registered new driver hub
usb-uhci.c: $Revision: 1.228 $ time 16:23:28 May 10 2000
usb-uhci.c: High bandwidth mode enabled
usb-uhci.c: USB UHCI at I/O 0xd400, IRQ 10
usb-uhci.c: Detected 2 ports
usb.c: new USB bus registered, assigned bus number 1
usb.c: USB new device connect, assigned device number 1
usb.c: kmalloc IF c12dd2e0, numif 1
usb.c: new device strings: Mfr=0, Product=2, SerialNumber=1
usb.c: USB device number 1 default language ID 0x0
Product: USB UHCI Root Hub
SerialNumber: d400
hub.c: USB hub found
hub.c: 2 ports detected
hub.c: ganged power switching
hub.c: standalone hub
hub.c: global over-current protection
hub.c: power on to power good time: 2ms
hub.c: hub controller current requirement: 0mA
hub.c: port 1 is removable
hub.c: port 2 is removable
hub.c: local power source is good
hub.c: no over-current condition exists
hub.c: enabling power on all ports
usb.c: hub driver claimed interface c12dd2e0
hub.c: port 1 connection change
hub.c: portstatus 300, change 3, Low Speed
hub.c: port 1 enable change, status 300
hub.c: port 2 connection change
hub.c: portstatus 101, change 3, High Speed
hub.c: portstatus 103, change 0, High Speed
usb.c: USB new device connect, assigned device number 2
usb.c: kmalloc IF c12ddc20, numif 1
usb.c: new device strings: Mfr=0, Product=0, SerialNumber=0
hub.c: USB hub found
usb-uhci.c: interrupt, status 2, frame# 1348
usb.c: hub driver claimed interface c12ddc20
hub.c: port 2 enable change, status 101
hub.c: already running port 2 disabled by hub (EMI?), re-enabling...
hub.c: portstatus 103, change 0, High Speed
usb.c: USB disconnect on device 2
hub.c: portstatus 103, change 0, High Speed
usb.c: USB new device connect, assigned device number 2
usb_control/bulk_msg: timeout
usb_control/bulk_msg: timeout
usb.c: registered new driver ov511
ov511.c: ov511 driver registered
usb.c: registered new driver usblp
usb_control/bulk_msg: timeout
usb_control/bulk_msg: timeout
usb_control/bulk_msg: timeout
usb.c: USB device not responding, giving up (error=-110)
hub.c: hub: disabling port 2
Thanks for help.
---------------------------------------------------------------------
To unsubscribe, e-mail: [EMAIL PROTECTED]
For additional commands, e-mail: [EMAIL PROTECTED]
