Hi,
Any suggestions for the problem outlined below would be most welcomed.
Thanks,
Mike
The problem:
Attempts to control a Kodak DC-265 camera, connected via USB fail.
Details:
The camera and cable work with another computer. Both computers
are running RH6.2/2.2.14 with the usb backport.
The camera is recognized - it shows up in /proc/bus/usb/devices.
Some interrupts occur when I attempt to access the camera. The
interrupt count in /proc/interrupts goes up. The count seems to
increment 1 time for each attempt to contact the camera. Seems
reasonable.
I have tried using both UHCI drivers.
>From the message log:
* camera on
usb.c: USB new device connect, assigned device number 2
dc2xx.c: USB Camera #0 connected
* camera off
usb.c: USB disconnect on device 2
dc2xx.c: USB Camera #1 disconnected
* ks -d /dev/dcxx0 status
usb_control/bulk_msg: timeout
usb_control/bulk_msg: timeout
usb_control/bulk_msg: timeout
usb_control/bulk_msg: timeout
(4 interrupts occur during this period - /proc/interrupts)
---------------------------------------------------------------------
To unsubscribe, e-mail: [EMAIL PROTECTED]
For additional commands, e-mail: [EMAIL PROTECTED]
