On Fri, Jun 14, 2013 at 8:35 AM, Greg Kroah-Hartman <gre...@linuxfoundation.org> wrote: > On Thu, Jun 13, 2013 at 03:41:17PM -0400, Alan Stern wrote: >> On Thu, 13 Jun 2013, Greg Kroah-Hartman wrote: >> >> > On Thu, Jun 13, 2013 at 10:54:13AM -0400, Alan Stern wrote: >> > > On Thu, 13 Jun 2013, Ming Lei wrote: >> > > >> > > > - using interrupt threaded handler(default) >> > > > 33.440 MB/sec >> > > > >> > > > - using tasklet(#undef USB_HCD_THREADED_IRQ) >> > > > 34.29 MB/sec >> > > > >> > > > - using hard interrupt handler(by removing HCD_BH in ehci-hcd.c ) >> > > > 34.260 MB/s >> > > > >> > > > >> > > > So looks usb mass storage performance loss can be observed with >> > > > interrupt threaded handler because one mass storage read/write sectors >> > > > requires at least 3 interrupts which wake up usb-storage thread 3 times >> > > > (each interrupt wakeup the usb-storage each time), introducing irq >> > > > threaded >> > > > handler will make 2 threads to be waken up about 6 times for one >> > > > read/write. >> > > > >> > > > I think usb mass storage transfer handler need to be rewritten, >> > > > otherwise >> > > > it may become worsen after using irq threaded handler in USB 3.0.(the >> > > > above device can reach >120MB/sec with hardware handler or tasklet >> > > > handler, >> > > > which means about ~3K interrupts/sec, so ~6K contexts switch in case of >> > > > using irq threaded handler) >> > > > >> > > > So how about supporting tasklet first, then convert to interrupt >> > > > threaded handler >> > > > after usb mass storage transfer is rewritten without performance loss? >> > > > (rewriting >> > > > usb mass storage transfer handler may need some time and work since >> > > > storage >> > > > stability/correctness is extremely important, :-) >> > > >> > > Maybe we should simply copy what the networking people do. They are >> > > very concerned about performance and latency; whatever technique they >> > > use should be good for USB too. >> > >> > Yes, but for "old-style" usb-storage, is this really a big deal? We are >> > still easily hitting the "line-speed" of USB for usb-storage with simple >> > machines, the bottlenecks that I'm seeing are in the devices themselves, >> > and then in the USB wire speed. >> >> What about with USB-3 storage devices? Many of them still use the >> bulk-only transport instead of UAS. They may push the limits up. > > Are they really? Have we seen that happen yet? With the number's I've
Yes, the device I am testing is bulk-only, no uas support , and it is very popular in market. > seen published, we are easily serving up enough data to keep the pipe > full, but that all depends on your CPU / host controller. > >> > Once hardware comes out that uses USB streams, and we get device support >> > for the UAS protocol, then we might have a need to change things, but at >> > this point in time, for the "old" driver, I think we are fine. >> > >> > Unless someone has a workload / benchmark that shows otherwise? >> >> The test results above show a 2.4% degradation for threaded interrupts >> as compared to tasklets. That's in addition to the bottlenecks caused >> by the device; no doubt it would be worse for a faster device. This >> result calls into question the benefits of threaded interrupts. >> >> The main reason for moving away from the current scheme is to reduce >> latency for other interrupt handlers. Ming gave two examples of slow >> USB code that runs in hardirq context now; with his change they would >> run in softirq context and therefore wouldn't delay other interrupts so >> much. (Interrupt latency is hard to measure, however.) > > Yes, I know that people keep wanting to worry about latency issues, and > the best answer for them has always been, "don't use USB." :) I think we can do it better, why don't do it? :-) > You suffer throughput issues with predicitable latency dependancies, so This patchset don't cause throughout degradation but decrease latency much, also has other advantages. > we need to be careful we don't slow down the 99% of the systems out > there that do not care about this at all. Considered great amount of ARM devices in market, I think we need to consider the problem on these devices, :-) Thanks, -- Ming Lei -- To unsubscribe from this list: send the line "unsubscribe linux-usb" in the body of a message to majord...@vger.kernel.org More majordomo info at http://vger.kernel.org/majordomo-info.html