On Mon, Nov 11, 2013 at 03:35:37PM +0200, Ivan T. Ivanov wrote:
> From: "Ivan T. Ivanov" <iiva...@mm-sol.com>
>
> PHY drivers keep track of the current state of the hardware,
> so don't change PHY settings under it.
>
> Signed-off-by: Ivan T. Ivanov <iiva...@mm-sol.com>
> ---
> drivers/usb/chipidea/ci_hdrc_msm.c | 9 ++-------
> 1 file changed, 2 insertions(+), 7 deletions(-)
>
> diff --git a/drivers/usb/chipidea/ci_hdrc_msm.c
> b/drivers/usb/chipidea/ci_hdrc_msm.c
> index e9624f3..338b209 100644
> --- a/drivers/usb/chipidea/ci_hdrc_msm.c
> +++ b/drivers/usb/chipidea/ci_hdrc_msm.c
> @@ -20,13 +20,11 @@
> static void ci_hdrc_msm_notify_event(struct ci_hdrc *ci, unsigned event)
> {
> struct device *dev = ci->gadget.dev.parent;
> - int val;
>
> switch (event) {
> case CI_HDRC_CONTROLLER_RESET_EVENT:
> dev_dbg(dev, "CI_HDRC_CONTROLLER_RESET_EVENT received\n");
> - writel(0, USB_AHBBURST);
> - writel(0, USB_AHBMODE);
> + usb_phy_init(ci->transceiver);
It will reset the PHY, but your comment is "don't change PHY settings under it"
> break;
> case CI_HDRC_CONTROLLER_STOPPED_EVENT:
> dev_dbg(dev, "CI_HDRC_CONTROLLER_STOPPED_EVENT received\n");
> @@ -34,10 +32,7 @@ static void ci_hdrc_msm_notify_event(struct ci_hdrc *ci,
> unsigned event)
> * Put the transceiver in non-driving mode. Otherwise host
> * may not detect soft-disconnection.
> */
> - val = usb_phy_io_read(ci->transceiver, ULPI_FUNC_CTRL);
> - val &= ~ULPI_FUNC_CTRL_OPMODE_MASK;
> - val |= ULPI_FUNC_CTRL_OPMODE_NONDRIVING;
> - usb_phy_io_write(ci->transceiver, val, ULPI_FUNC_CTRL);
> + usb_phy_notify_disconnect(ci->transceiver, USB_SPEED_UNKNOWN);
Where you have implemented .notify_disconnect?
I have not found it at your phy driver.
--
Best Regards,
Peter Chen
--
To unsubscribe from this list: send the line "unsubscribe linux-usb" in
the body of a message to majord...@vger.kernel.org
More majordomo info at http://vger.kernel.org/majordomo-info.html
