On Wed, Oct 21, 2015 at 10:39:00AM +0800, Peter Chen wrote: > On Tue, Oct 20, 2015 at 02:09:38PM -0200, Fabio Estevam wrote: > > Hi Peter, > > > > On Mon, Oct 19, 2015 at 12:50 AM, Peter Chen <peter.c...@freescale.com> > > wrote: > > > > > Add linux-usb. > > > > > > Patryk, your problem is you may need to open 24M OSC for HUB 2514 > > > manually, and you have used IMX6QDL_CLK_CKO for it in the design, > > > but this clock is not controller's clock, controller's clock has > > > already decided at SoC dts file (imx6qdl.dtsi), you don't need to > > > override it at board's dts file. > > > > > > You can try delete clock property at imx6qdl-udoo.dtsi, if it still > > > can't work, try to open IMX6QDL_CLK_CKO at one place to test. > > > > What is the appropriate place to acquire and enable the USB hub clock? > > > > This issue has appeared several times and it seems we don't have a > > solution for this yet. > > > > Any suggestions? > > Add Alan. > > Hi Alan, we have several designs that the on-board HUB need to > be reset by gpio pin and its clock is also from the board or > the SoC. Any suggestions how to add these platform information > for HUB device?
How about putting it in the device tree? http://www.firmware.org/1275/bindings/usb/usb-1_0.ps clocks and reset-gpios properties could be added to the USB hub node. regards Philipp -- To unsubscribe from this list: send the line "unsubscribe linux-usb" in the body of a message to majord...@vger.kernel.org More majordomo info at http://vger.kernel.org/majordomo-info.html
